Black & Decker GH710 Manuel d'instructions télécharger pdf (Page 3)

• AVOID ACCIDENTALLY STARTING – Donʼt carry plugged-in

tool with finger on trigger.

• DO NOT FORCE THE TOOL – at a rate faster than the rate at

which it is able to cut effectively.

• USE THE RIGHT TOOL – Do not use this tool for any job except

that for which it is intended.

• DON’T OVERREACH – Keep proper footing and balance at all times.

• DON’T ABUSE CORD – Donʼt yank cord from power supply.

Keep cord from heat, oil, and sharp edges.

• DAMAGE TO UNIT – If you strike or become entangled with a

foreign object, stop tool immediately, unplug, check for damage

and have any damage repaired before further operation is

attempted. Do not operate with a broken hub or spool.

• DAMAGE TO CORD – Keep power cord away from rotating line.

If you damage the cord, unplug it from the power supply before

moving the tool or examining the damage. A damaged cord must

be replaced before further use.

• DISCONNECT TOOL – when not in use, when replacing line, or

prior to cleaning.

• AVOID DANGEROUS ENVIRONMENTAL CONDITIONS – Do

not use electric tools in damp or wet locations. Follow all

instructions in this Instruction Manual for proper operation of your

tool. Donʼt use the tool in the rain.

• DO NOT OPERATE portable electric tools in gaseous or

explosive atmospheres. Motors in these tools normally spark, and

the sparks might ignite fumes.

• STORE IDLE TOOLS INDOORS – When not in use, tools

should be stored indoors in a dry, locked-up place out of reach of

children.

• GROUND FAULT CIRCUIT INTERRUPTER (GFCI) protection

should be provided on the circuits or outlets to be used for the

gardening appliance. Receptacles are available having built in

GFCI protection and may be used for this measure of protection.

• SECURE EXTENSION CORD using the cord retainer shown in

Figure H.

• STAY ALERT – Do not operate this unit when you are tired, ill,

or under the influence of alcohol, drugs, or medication

• MAINTAIN APPLIANCES WITH CARE – Follow instructions in

maintenance section. Inspect extension cords periodically and

replace if damaged. Keep handles dry, clean and free from oil and

grease.

• CHECK DAMAGED PARTS – Before further use of the

appliance, a guard or other part that is damaged should be

carefully checked to determine that it will operate properly and

perform its intended function. Check for alignment of moving

parts, binding of moving parts, breakage of parts, mounting, and

any other condition that may affect its operation. A guard or other

part that is damaged should be properly repaired or replaced by

an authorized service center unless otherwise indicated

elsewhere in this manual.

WARNING: Do not use tool if the switch trigger does not turn

the tool on or off. Any tool that can not be controlled with the switch

trigger is dangerous and must be repaired.

WARNING: When servicing double insulated tools, USE

ONLY IDENTICAL REPLACEMENT PARTS. Replace or repair

damaged cords.

WARNING: To prevent electrical shock hazard, use only with

an extension cord suitable for outdoor use. Always connect extension

cords to a fused line or one protected by a circuit breaker.

• DO NOT immerse tool in water or squirt it with a hose. DO NOT

allow any liquid to get inside it.

• DO NOT store the tool on or adjacent to fertilizers or chemicals.

• DO NOT clean with a pressure washer.

SAVE THESE INSTRUCTIONS

1 2 3 4 5 6 7 8 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Black & Decker GH710 Manuel d'instructions Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Black & Decker GH710