Black & Decker Spacemaker CG700 Manuel d'utilisateur télécharger pdf (Page 12)

8. If you determined you need

Spacer Bars (See Step # 2, page

9), place the Spacer Bars on top of

each Bracket so that the 2 small

tabs on the bars fit into the

notches on the Brackets. Slide the

Mounting Bracket and Spacer

Bars above the nuts through the

U-shaped openings on the

Bracket. The Bracket will then be

resting on the nuts. (Figure M)

9. Push the Spacer Bars/Bracket

up against the screws and

forward toward the front of the

cabinet. Tighten the screw/nut

assembly with a screwdriver until

the Spacer Bars/Bracket just

touches the bottom of the cabinet.

(Figure N) The Bracket should

move freely front to rear in the slot

to fine tune the fit of the Toaster to

the cabinet front. Repeat Steps 8

and 9 for the other Bracket.

10. Hold the Toaster in front of you

and push it forward into the slots

on the Mounting Brackets until it

locks into place. The Metal Lip on

the top of the Toaster should rest

against the cabinet front. (Figure

O) The front of the Toaster will

extend 1

1

⁄2" beyond the front of the

cabinet.

12

Figure O

Figure N

Figure M

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Commentaires sur ces manuels

Pas de commentaire