Black & Decker FP1560 Instructions d'exploitation télécharger pdf (Page 36)

Chateau™

20011956

Troubleshooting

If erratic system behavior is observed that cannot be resolved by the methods outlined below, ensure that there is

not a transmitter with batteries installed that may be interfering. If a transmitter is packed with batteries installed, its

buttons may be depressed sending a constant signal which can interfere with the transmission of desired signals. A

transmitter with new batteries can have a range of over 100’ (30.4 m).

Module will not learn trans-

mitter

• Ensure the REMOTE/OFF switch on the side of the module is set to REMOTE.

• Make sure the batteries in both the transmitter and receiver are installed in the

proper direction and are not drained. Individual battery voltage should be no less

than 1.4V for AA and AAA batteries, 2.8V for button cells, and 9,0V for 12V batter-

ies.

• Verify the transmitter indicates a signal is being sent. With thermostat transmit-

ters, the LCD display should indicate ON or OFF depending on which button is

being pressed. The LED indicator should illuminate on wall transmitters and on/off

hand-held transmitters. Buttons should be pressed and held for 1 to 2 seconds to

ensure a complete signal is sent.

• Make sure the transmitter is within the 20’ (6 m) operational range of the receiver.

• Ensure the 4-pin lead-set is securely connected from the battery pack to the

control module’s AUX connection. If the A/C power adapter is used, make sure the

leads from the adapter are securely connected to the POWER terminals on the

control module.

• Press and hold the LEARN button on the module for approximately 10 seconds

to clear the memory (you should hear a series of beeps from the receiver). Then

press and release the learn button (you should hear a single beep from the

receiver), immediately press either the ON or OFF button on the transmitter (you

should hear a series of beeps indicating the transmitter code has been learned).

• Verify the gas supply is turned on.

• Verify the receiver is receiving the signal from the transmitter by listening for a

beep from the receiver when ON is pressed on the transmitter. If you do not hear

a beep, ensure the module has learned the transmitter (see above).

• Ensure the orange lead from the pilot assembly igniter is securely connected to

the terminal labeled “I” and the white lead from the ﬂame rectiﬁcation sensor is

securely connected to the terminal labeled “S” on the control module.

• Make sure the orange and white leads from the module are securely connected to

the terminals labeled “PILOT” on the valve body.

• Ensure the black GROUND wire is securely connected to an appropriate metal

portion of the valve or pilot assembly. A proper ground is essential to spark

igniter operation.

• Make certain the pilot ﬂame is in contact with the ﬂame rectiﬁcation sensor on the

pilot assembly. This valve is equipped with a pilot ﬂame adjustment screw. If the

pilot ﬂame is too small it will not contact the ﬂame rectiﬁcation sensor and will not

complete the safety circuit.

• Ensure the CONTINUOUS PILOT switch on the control module is set to OFF.

• Check the handheld transmitter display for the word “PILOT” on the LCD screen. If

this is displayed, press and hold the CONTINUOUS PILOT button on the hand-

held transmitter for approximately 10 seconds to turn off continuous pilot mode.

Pilot will not light/stay lit

Pilot ﬂame is always on/ will

not extinguish

American Flame Gas Control System

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Black & Decker FP1560 Instructions d'exploitation Page 36

Commentaires sur ces manuels