Black & Decker CS1040L Manuel d'instructions télécharger pdf (Page 9)

9

REMOVING THE BLADE (CS1030L)

(FIG. 12 & 13)

• Prevent spindle rotation by engaging

the teeth of the saw blade into a piece

of scrap wood.

• Loosen and remove the blade retaining

screw (16) by turning it counter-

clockwise using the wrench (10)

supplied.

• Remove the outer washer (17).

• Remove the saw blade (7).

ATTACHING THE BLADE (CS1030L)

• Place the saw blade (7) onto the inner

flange (18), making sure that the arrow

on the blade points in the same

direction as the arrow on the tool.

• Fit the outer washer (17) on the

spindle, with the raised part pointing

away from the saw blade.

• Insert the blade retaining screw (16)

into the hole.

• Prevent spindle rotation by engaging

the teeth of the saw blade into a piece

of scrap wood.

• Securely tighten the blade retaining

screw by turning it clockwise using the

wrench (10) supplied.

WARNING: To reduce the risk of

serious personal injury, read, understand

and follow all important safety warnings

and instructions prior to using tool.

GENERAL CUTS (IMPORTANT: READ

SAFETY WARNINGS AND

INSTRUCTIONS. )

GUARD AGAINST KICKBACK

With unit unplugged, follow all assembly,

adjustment and set up instructions.

Make sure lower guard operates. Select

the proper blade for the material to be cut.

• Measure and mark work for cutting.

• Support and secure work properly (See

Safety Rules and Instructions).

• Use appropriate and required safety

equipment (See Safety Rules).

• Secure and maintain work area (See

Safety Rules).

• With plug inserted and guard closed,

make sure switch turns saw on and off.

WARNING: It is important to support

the work properly and to hold the saw

firmly to prevent loss of control which

could cause personal injury. Figure 3

illustrates recommended hand position.

ATTACHING AND REMOVING THE RIP

FENCE (INCLUDED WITH CS1040L)

(FIG. 14)

The rip fence is used to saw in a straight

line parallel to the edge of the workpiece.

ATTACHING

• Loosen the locking knob (19).

• Insert the rip fence (20) through the

openings (21).

• Slide the rip fence into the desired

position.

• Tighten the locking knob.

REMOVING

• Loosen the locking knob.

• Pull the rip fence out of the tool.

NOTE: If you do not have a proper fitting

fence, use a straight edge guide in contact

with the edge of the shoe to improve

accuracy of cut and reduce the possibility

of binding and kickback.

12

13

10

16

17

7

18

14

19

21

20

21

642743-00 CS1030 CS1040L 4/13/06 10:06 AM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Commentaires sur ces manuels

Pas de commentaire