BLACK+DECKER CS1014 Manuel d'utilisation et d'entretien télécharger pdf (Page 9)

9

cuts at desired depth.

• Tilt the saw forward and rest front of

the foot plate on material to be cut.

• Using the retracting lever, retract lower

blade guard to an upward position.

Lower rear of foot plate until blade

teeth almost touch cutting line.

• Release the blade guard (its contact

with the work will keep it in position to

open freely as you start the cut).

Remove hand from guard lever and

firmly grip secondary handle (3), as

shown in figure 11. Position your body

and arm to allow you to resist kickback

if it occurs.

• Make sure blade is not in contact with

cutting surface before starting saw.

• Start the motor and gradually lower the

saw until its foot plate rests flat on the

material to be cut. Advance saw along

the cutting line until cut is completed as

shown in figure 11.

• Release trigger and allow blade to stop

completely before withdrawing the

blade from

the material.

• When starting each new cut, repeat as

above.

WRENCH STORAGE (FIG.12)

The spanner wrench (8) can be stored

on the saw shoe as shown in figure 12.

MAINTENANCE

Use only mild soap and damp cloth to

clean the tool. Never let any liquid get

inside the tool; never immerse any part

of the tool into a liquid.

IMPORTANT: To assure product

SAFETY and RELIABILITY, repairs,

maintenance and adjustment (other than

those listed in this manual) should be

performed by authorized service centers

or other qualified service organizations,

always using identical replacement

parts.

LUBRICATION

Black & Decker tools are properly

lubricated at the factory and are ready for

use.

ACCESSORIES

Recommended accessories for use with

your tool are available from your local

retailer.

WARNING:The use of any accessory not

recommended for use with this tool could be

hazardous. Use only 7-1/4 “ (184mm) blades

with 5/8” diameter arbor.

SERVICE INFORMATION

All Black & Decker Service Centers are

staffed with trained personnel to provide

customers with efficient and reliable

power tool service. Whether you need

technical advice, repair, or genuine

factory replacement parts, contact the

Black & Decker location nearest you. To

find your local service location, refer to

the yellow page directory under "Tools—

Electric" or call: 1-800-544-6986 or visit

www.blackanddecker.com

FULL TWO-YEAR HOME USE

WARRANTY

Black & Decker (U.S.) Inc. warrants this

product for two years against any defects

in material or workmanship. The

defective product will be replaced or

repaired at no charge in either of two

ways.

The first, which will result in exchanges

only, is to return the product to the retailer

from whom it was purchased (provided

that the store is a participating retailer).

Returns should be made within the time

period of the retailerʼs policy for

exchanges (usually 30 to 90 days after

the sale). Proof of purchase may be

required. Please check with the retailer

for their specific return policy regarding

returns that are beyond the time set for

exchanges.

The second option is to take or send the

8

11

12

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Commentaires sur ces manuels

Pas de commentaire