European technical approval
ETA-08/0376
English translation prepared by DIBt
Page 3 of 44 | 4 April 2013
Z14391.13 18.04.2013 / DRAFT / 8.06.01-445/12
II SPECIFIC CONDITIONS OF THE EUROPEAN TECHNICAL APPROVAL
1 Definition of product/ products and intended use
1.1 Definition of the construction product
The "Powers PURE150-PRO Injection resin with anchor rod for concrete" is a bonded anchor
consisting of a cartridge with injection mortar Powers PURE150-PRO and a steel element. The
steel elements are commercial threaded rods according to Annex 3 in the range of M 8 to M 30,
reinforcing bar according to Annex 4 in the range of Ø 8 to Ø 32 or threaded sleeves with
internal thread according to annex 5 size M 8 to M 20.
The steel element is placed into a drilled hole filled with injection mortar and is anchored via the
bond between metal part, injection mortar and concrete.
An illustration of the product and intended use is given in Annexes 1 and 2.
1.2 Intended use
The anchor is intended to be used for anchorages for which requirements for mechanical
resistance and stability and safety in use in the sense of the Essential Requirements 1 and 4 of
Council Directive 89/106 EEC shall be fulfilled and failure of anchorages made with these
products would cause risk to human life and/or lead to considerable economic consequences.
Safety in case of fire (Essential Requirement 2) is not covered in this European technical
approval.
The anchor is to be used only for anchorages subject to static or quasi-static actions in
reinforced or unreinforced normal weight concrete of strength classes C20/25 at minimum and
C50/60 at most according to EN 206:2000-12.
The anchor may be used in cracked or non-cracked concrete.
The anchor may be installed in dry or wet concrete or in flooded holes.
The anchor with threaded rods or rebar may also be used under seismic action (anchor
performance category C1).
The anchor may be used in the following temperature ranges:
Temperature range I: -40 °C to +40 °C (max long term temperature +24 °C and
max short term temperature +40 °C)
Temperature range II: -40 °C to +60 °C (max long term temperature +43 °C and
max short term temperature +60 °C)
Temperature range III: -40 °C to +72 °C (max long term temperature +43 °C and
max short term temperature +72 °C)
Elements made of zinc coated steel:
The element made of zinc plated or hot dipped galvanised steel may only be used in structures
subject to dry internal conditions.
Elements made of stainless steel A4:
The element made of stainless steel 1.4401 or 1.4571 may be used in structures subject to dry
internal conditions and also in structures subject to external atmospheric exposure (including
industrial and marine environment), or exposure to permanently damp internal conditions, if no
particular aggressive conditions exist. Such particular aggressive conditions are e.g. permanent,
alternating immersion in seawater or the splash zone of seawater, chloride atmosphere of indoor
swimming pools or atmosphere with extreme chemical pollution (e.g. in desulphurization plants
or road tunnels where de-icing materials are used).
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels