Black & Decker VEC1029FPOB Manuel d'utilisateur télécharger pdf (Page 9)

USING THE EMERGENCY AREA LIGHT

The Area Light is controlled by an ON/OFF pushbutton (both are located on the Unit’s

Front Panel). Make sure the Area Light is turned OFF when the unit is being recharged

or stored.

USING THE CLOCK/ALARM CLOCK

Programming the Clock and

Alarm Clock

By default, the Digital Display shows the time (hours:

minutes (AM/PM), with the seconds displayed in the

upper right corner). Note that the back light will

activate automatically whenever any button is

pressed.

This unit allows the user to program in two separate

alarm times. Each Alarm Clock setting can be

programmed to respond at the programmed time

with either the Alarm sound or automatically turn the

Radio ON (to the last station tuned in).

Before using the Alarm Clock feature, you must

program in the time. Refer to the above enlargement of the Radio Panel to locate

referenced buttons and controls. Make sure the Radio ON/OFF Pushbutton is in the

OFF position, as this puts the unit in Clock mode (where you can program the clock

and alarm time and settings).

Setting Up the Clock

1. Press the MEM/CLOCK Pushbutton once. The numbers on the Digital Display will

blink.

2. Press the HOUR Pushbutton until the correct hour displays (cycling through from

AM to PM).

3. Press the MIN Pushbutton until the correct minute displays.

4. Press the MEM/CLOCK Pushbutton to save. The unit automatically goes to alarm

set-up. Simply press the MEM/CLOCK Pushbutton twice to exit and save all

changes without setting up an alarm time.

Setting Up the Alarm Clock

5. To set the Alarm Clock, press the MEM/CLOCK Pushbutton until the numbers on

the Digital Display blink and “AL1” (Alarm setting 1) appears at the bottom of

the display.

6. Program in the time for the first alarm as outlined in steps 2 through 3 above.

7. Press the MEM/CLOCK Pushbutton to save the first alarm setting. The unit

automatically goes to second alarm set-up. The numbers on the Digital Display

will blink and “AL2” (Alarm setting 2) will appear at the bottom of the display.

8. Program in the time for the second alarm as outlined in steps 2 through 3 above.

9. When finished, press the MEM/CLOCK Pushbutton once more to save all settings.

Alarm Clock Settings

Pressing the “AL1 SET” cycles through the Alarm/Radio/OFF setting for the first alarm.

Pressing the “AL2 SET” cycles through the Alarm/Radio/OFF setting for the second alarm.

VEC1029FPOB_ManualEN_101606 10/16/06 5:17 PM Page 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Black & Decker VEC1029FPOB Manuel d'utilisateur Page 9

Commentaires sur ces manuels