16
satisfactory operation depends upon proper tool care
and regular cleaning.
Warning! Before performing any maintenance on
corded/cordless power tools:
Switch off and unplug the appliance/tool.•
Or switch off and remove the battery from •
the appliance/ tool if the appliance/tool has a
separate battery pack.
Or run the battery down completely if it is •
integral and then switch off.
Unplug the charger before cleaning it. Your •
charger does not require any maintenance apart
from regular cleaning.
Regularly clean the ventilation slots in your appliance/
tool/ charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Regularly open the valve adaptor and tap it to remove
any dust from the interior.
Troubleshooting
Replacing the fuse in the vehicle dc
accessory plug
Remove the cap by turning it counter-clockwise.•
Loosen the cap and centre pin.•
Remove the fuse.•
Fit a new fuse of the same type and size •
(8A/250V).
Refit the cap and centre pin.•
Tighten the cap by turning clockwise onto the •
plug.
Protect the environment
Separate collection. This product must no be
disposed of with normal household waste.
Should you find one day that your Black & Decker
product needs replacement, or if it is of no further
use to you, do not dispose of it with household waste.
Make this product available for separate collection.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
Batteries
At the end of their useful life, discard batteries
with due care for our environment:
Do not short-circuit the battery terminals.•
Do not dispose of the battery(s) in a fire as this may •
result in a risk of personal injury or an explosion.
Run the battery down completely, then remove it from •
the tool.
Batteries are recyclable. Place the battery(s) in a •
suitable packaging to ensure that the terminals cannot
be short-circuited. Take them to any authorised repair
agent or a local recycling station.
PRINTED IN CHINA
Inatorwill
notoperate
PROBLEM POSSIBLECAUSE
POSSIBLESOLUTION
12Voltadaptor
notconnected
Accessory
socketnotlive
Nopreset
valveset
Thefuseinthe
12Voltadaptor
isblown
Cordorswitchis
damaged.
Connectthe12Volt
adaptor
Turnkeytoaccessory
position
Setpresetvalue
Replacethefusewith
oneofthesamesize
andtype(8A/250V)
Havethecordor
switchreplacedata
Black&Decker
ServiceCentreor
Authorized
ServiceCentre.
Technical Data
ASI200
Input voltage Vdc 12
Input current A 8
Pressure (max) psi / bar 120 / 8.27
Weight kg 1.12
ENGLISH
Commentaires sur ces manuels