Initial Set Up
Notice: To prevent damage to compressor, allow unit to sit upright for at least 4 hours
prior to operating.
1. Open door.
2. If using a 5 gallon bottle use the bottle probe as it is supplied. If
you desire to use a lighter weight 3 gallon bottle, remove the
bottom half of the probe by pulling it apart. Save for future use.
3. Slide bottle tray out and place fresh bottle on tray.
4. Clean bottle cap and neck with a soft cloth and warm soapy water,
then rinse prior to using.
5. Remove tamper seal from bottle cap. Do NOT remove plastic cap.
Note – If your water bottle does not have a sealed cap with a plug,
use the cap supplied with this unit. Simply snap it onto your bottle.
Make sure the cap is completely installed and there is a tight seal.
6. As shown in illustration A, use tool to apply slight pressure
downwards on cap plug until it releases into the bottle.
Note – NEVER use probe to release cap.
7. As shown in illustration B, slide probe into bottle. Push
lightly down on head to create a tight seal with the bottle.
Note – Unit will NOT operate properly unless there is a
tight seal between the probe head and the bottle.
8. Slide tray into cabinet and close door completely.
Note – Unit will NOT operate properly with the door open.
9. Plug cord into a properly grounded wall outlet. The unit
will come ON and start pumping air into the bottle which
will force the water from the bottle into the hot and cold
water reservoirs.
Note -
- If water does NOT start pumping, open the door and
make sure probe has a tight seal on the bottle.
- It will take up to 3 minutes for the reservoirs to load.
During this time the pump will run on and off. This is
normal.
- Each time you dispense water from the taps the pump, will come on.
10. Turn energy saving switch on back of dispenser to ON. This switch controls the
heating of water. If you do not want hot water, turn this switch OFF.
Initial Rinsing of Water Lines
This unit has been tested and sanitized prior to packing and shipping. During transit dust
and odors can accumulate in the tank and lines. Dispense and dispose at least one
quart of water prior to drinking any water.
A
(12 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels