Black & Decker EM100B Manuel d'instructions télécharger pdf (Page 9)

Put Digital Display Beep!

into ID mode Beep!

Press and hold until

you hear two (2) beeps.

Reset Meter Sensor Press Beep!

Digital Display will beep.

Data will appear within

two (2) minutes.

05 DETERMINE BILLING MODE AND BILLING RAT E

04 SYNCHRONIZE METER SENSOR AND DIGITAL DISPLAY

In order to display the cost of your electricity, you need to program the Digital Display with

information from your electricity bill.

There are three ways you may be billed for electricity:

• Flat Rate. See example on page 1 8

You are charged the same amount per kilowatt-hour (kWh) no matter how much you

use or what time of day you use it.

• Tiered Rates. See example on page 2 0

You are charged one rate for an initial number of kilowatt-hours, then a higher rate if

you exceed that threshold. There may be several thresholds.

• Time-of-Use Rates. See example on page 2 3

You are charged a different rate depending on the time of day. There may be two rates

(on-peak and off-peak) or three rates (on-peak, mid-peak, and off-peak).

Get a recent electric bill and determine how you are charged.

Then, go to the appropriate page and fill out the form with

your billing information. This will make it easier to program your

Power Monitor.

If there is a problem, please read the Troubleshooting section in this Instruction Manual.

S T E P A C T I O N / P R E S S D I S P L AY

The prog/sync button on top of the Digital Display is used to enter

Program Mode and to enter data for each programming step.

The Reset Button is located on the front of the Meter

Sensor, adjacent to the Status Indicator.

Now, you can go indoors and, referring to your electric bill, program your billing

rates into the Digital Display.

The data appearing on your screen is an accurate measure of your electricity consump-

tion. To see an accurate measure of your electricity cost, follow the next section to

program your billing rates.

If numbers are not appearing on your screen after 2 minutes, go to section 11,

Troubleshooting and Q&A.

0 3 I N S TALLING YOUR METER SENSOR

TYPE 3—ELECTRONIC WITH OPTICAL PORT ON TO P

9 . You may need to slide the Sensor towa rd you until

the Sensor LEDs are dire c t l y over the optical port on

the mete r.

If the STATUS indicator does not begin to blink within

one minu t e, continue to reposition the Sensor until

you have proper alignment.

N OT E : To maximize batte ry life, the indicator stops fl a s h i n g

a f ter about two minu t e s .

10 . When the STATUS light begins to blink, tighten the

clamping strap tight so the sensor cannot

m o ve. Close the latch.

I n s t allation is complete! Go to Section

4, Sy n c h r o n i z e Meter Sensor

Latch Raised

90539499 01 EM100B.qxd 7/7/08 10:05 AM Page 16

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Commentaires sur ces manuels

Pas de commentaire

Black & Decker EM100B Manuel d'instructions Page 9

Commentaires sur ces manuels