Black & Decker EM100B Manuel d'instructions télécharger pdf (Page 4)

Go to your electric meter and take the following

items with you:

• This Manual • A clean damp cloth

• Meter Sensor • 1 large Flat Head screwdriver

• Digital Display • Clear Alignment Template (if you have a Type 3 meter)

• Rubber Shim • A pen or pencil

Determine your electric meter type

In order to configure your Meter Sensor and program your Digital Display properly,

you must first determine what type of electric meter you have.

There are three types of electric meters:

0 3 I N S TALLING YOUR METER SENSOR

0 2 U N D E R S TANDING YOUR POWER MONITO R

Clamping Strap

Sensor Arm (extended)

Sensor Head

Sensor LEDs

Wire

Wire Cavity

Sensor Arm

Latch Cover

Battery Compartment

Latch

Battery Compartment

Cover

Knowing the Digital Display

prog/sync Button

Screen

tare Button

Increase Button

Decrease Button

clr Button

Display Stand

TYPE 1—Electromechanical

This type of meter has dials and a spinning disk.

Note – If your meter has dials, but the spinning disk is not

visible from the front of the meter, call the Black & Decker

Help Line at 1-800-544-6986.

TYPE 2—Electronic with optical port

on the face

The optical port looks like an LED, and may appear anywhere

on the face. Some meters have two ports.

TYPE 3—Electronic with optical

port on the top

The optical port looks like a clear plastic cylinder that

protrudes from the top of the electric meter.

Knowing the Meter Sensor

If this is your meter ty p e, proceed to the next page.

If this is your meter ty p e, proceed to page 10 .

If this is your meter ty p e, proceed to page 13 .

Optical Port

90539499 01 EM100B.qxd 7/7/08 10:05 AM Page 6

1 2 3 4 5 6 7 8 9 ... 22 23

Commentaires sur ces manuels

Pas de commentaire

Black & Decker EM100B Manuel d'instructions Page 4

Commentaires sur ces manuels