Black & Decker EM100B Manuel d'instructions télécharger pdf (Page 3)

0 1 B E F ORE YOU BEGIN

Digital Display Stand

Remove the battery compartment cover on the

back of the Digital Display, insert two AA

batteries (not included) in the proper orientation,

and replace the battery compartment cover.

The Digital Display can be mounted to a wall using

the keyhole hanger in the back, or it can stand alone

using the plastic stand.

To attach the stand to the Digital Display, insert the plastic

tabs into the square recesses on the lower back of the Digital

Display as shown. Once all four tabs are in the recesses,

push up on the stand to lock it in place.

Keyhole Hanger

0 1 B E F ORE YOU BEGIN

Verify the contents of the box.

Verify that your package contains all of the components shown below. If any item is

missing, please call 1-800-544-6986.

1 Rubber Shim

3 Instruction

Manuals

(English, Spanish

and French)

Digital Display

Meter Sensor

(with clamping strap)

1 Clear Alignment

Template

You will also need:

Four (4) AA batteries (not included)

Do not use rechargeable batteries

Use lithium batteries in the sensor for best

performance in freezing temperatures (below 32°F, 0°C)

Copy of your Electricity Bill

1 large Flat Head Screwdriver (not included)

A clean damp cloth (not included)

Using a large Flat Head

Screwdriver, loosen the

slotted screw and open the Meter Sensor

battery compartment cover. Insert two AA

batteries (not included) in the orientation

indicated, then close the battery

compartment cover and tighten the screw

until snug.

About 10 seconds after installing the batteries,

the status indicator will light up solid red, and the

sensor will look for a signal from a meter. If the sensor is

not installed on a meter within 20 minutes, the status light will

blink rapidly. This is normal, and you can press the RESET button

to restart the search if your installation is interrupted.

Make sure that the battery closest to the Sensor Arm goes in with its positive end

(+) facing inward. Refer to (+) and (-) markings on the circuit board.

Install Meter Sensor Batteries

Install Digital

Display Batteries

Digital Display

Stand

Status

90539499 01 EM100B.qxd 7/7/08 10:05 AM Page 4

1 2 3 4 5 6 7 8 ... 22 23

Commentaires sur ces manuels

Pas de commentaire

Black & Decker EM100B Manuel d'instructions Page 3

Commentaires sur ces manuels