Black & Decker EM100B Manuel d'instructions télécharger pdf (Page 17)

09 PROGRAM DIGITAL DISPLAY –

TIME-OF-USE RATE BILLING

Select which Rate Type

applies to the first Time Slot.

Enter start time for second

Time Slot. Enter hours.

Then enter minutes.

/\ \/

Select which Rate Type

applies to the second Time Slot.

Continue this process to enter

data for all Time Slots from

your billing schedule in

section 05.

If you have fewer than 6 time

slots, hold down prog/sync to exit

Program Mode.

Programming is complete!

S T E P A C T I O N / P R E S S D I S P L AY

Note: Before you begin programming your Digital Display for Time-of-Use Rate Billing,

you will need to refer to the Billing Rates and Time Slots you recorded in section 05.

Go to Section 10, Using Yo u r

Power Monito r.

Beep!

09 PROGRAM DIGITAL DISPLAY –

TIME-OF-USE RATE BILLING

Select whether Time-of-Use

Billing applies on weekends.

Note: Flashing SUN and SAT

indicate Time-of-Use Billing

DOES NOT apply on weekends.

Enter Off-Peak Billing Rate.

To make the numbers change

faster, you can press and hold

the or .

For Three Rate (3-PEAK)

Billing only:

Enter Mid-Peak Billing Rate.

Enter On-Peak Billing Rate.

Enter start time for first

Time Slot. Enter hours.

Then enter minutes.

S T E P A C T I O N / P R E S S D I S P L AY

Note: Before you begin programming your Digital Display for Time-of-Use Rate Billing,

you will need to refer to the Billing Rates and Time Slots you recorded in section 05.

C o n t i n ue on the top of the next page.

90539499 01 EM100B.qxd 7/7/08 10:05 AM Page 32

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

Commentaires sur ces manuels

Pas de commentaire

Black & Decker EM100B Manuel d'instructions Page 17

Commentaires sur ces manuels