Black & Decker TCM850 Manuel d'utilisateur télécharger pdf (Page 9)

The Controls

Heat Selection

Switch

Start

switch

Empty water

light

Clean Filter

light

Drying

light

Timer

Control

The drying time for both heat settings is controlled by the timer. All you

have to do is turn the Timer Control clockwise until the required time

appears in line with the indicator.

NEVER WIND THE TIMER CONTROL ANTI-CLOCKWISE.

The “Guide to Drying Times” section will tell you how much time you’ll

need for various loads.

To select high heat (Cottons), the Heat Selection switch must be IN.

To select Low heat (Acrylics and Synthetics) the Heat Selection switch

must be OUT.

See section “Guide to Drying Times”.

Press and release the START button to commence a drying program

(The drying time must have been selected first).

This light glows during the drying part of the programme except for the

short periods during the drum reverse action.

When the door is opened this light will glow to remind you to clean the

filter.

This light will glow when the water container is full.

You should not wait for this light to glow before emptying the water

container, but empty it after each load (see section “Emptying the

Water Container”).

NOTE: When the light glows you must stop the dryer and empty the

water container.

If the water light glows during a drying cycle the timer will advance to

the Cool Tumble Phase without drying the load.

The light will take approximately 10 seconds to go out after replacing

the empty container.

Setting the timer

Selecting the

required Heat

Setting

Starting the Dryer

Drying light

Clean Filter light

Empty Water

Light

NOTE: If the door is opened during a programme the

Dryer will automatically stop.

To continue the programme after closing the door, the

START button must be pressed.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Black & Decker TCM850 Manuel d'utilisateur Page 9

Commentaires sur ces manuels