Black & Decker Door SS925 Manuel d'utilisateur télécharger pdf (Page 9)

9

A. Inverter

1. Set the 12Vdc and Inverter Selector

(4) to the “INVERTER” position.

2. The 12Vdc and Inverter Indicator (5)

will come on (green).

3. Ensure the rated power of the

appliance you are plugging in is

120Vac and not more than 25W,

otherwise the internal overload

protection will be executed and the

output of inverter will be cut off. For

output power greater than 20W, the

inverter may deliver the power to the

appliance for a shorter duration

(about 15 minutes).

4. Insert the plug of the appliance into

the Inverter Outlet (15) as shown in

figure D.

5. The output will be 120Vac 60Hz.

6. Switch on the appliance.

7. When the Inverter Outlet is not in use,

be sure the cap is kept closed.

B. 12Vdc Accessory Socket

1. Set the 12Vdc and Inverter Selector

(4) to “12V” position.

2. 12Vdc and Inverter Indicator (5) will

come on.

3. Insert the plug of the appliance into

the 12Vdc Outlet (14). Be sure the rated

voltage of the appliance is 12Vdc and

the rated current is not greater than

2.5A.

4. Switch on the appliance.

5. When the 12Vdc Outlet is not in use,

be sure the cap is kept closed to prevent

foreign material from entering the outlet

and causing a short-circuit.

WARNING: Do not insert a cigarette

lighter into the 12Vdc Outlet (14).

C. Overload Protection

1. If the output current of inverter or

12Vdc Outlet is higher than the preset

limit, the Overload Indicator (11) will turn

on and the output will be disabled. The

12Vdc and Inverter Indicator (5) will turn

off.

2. Unplug the appliance and reset the

overload protection by pressing the

12Vdc and Inverter Reset Button (10).

The Overload Indicator (11) will turn off.

BULB REPLACEMENT (USE DC12V

0.4A BULB)

NOTE: If bulb has been lit, let it cool for

several minutes before changing.

A. Room Light

1. Open the cover of the room light as

shown in figure E.

2. Twist bulb until the “v” shaped notch in

rim of the bulb aligns with triangular

shaped retainer in the hole of the

reflective housing then pull straight out.

3. Insert new bulb by aligning the

triangular notch in the rim of the bulb with

the triangular tip retainer. Push in on bulb

and twist a half turn to lock bulb in place.

B. Flashlight

1. Unscrew the lens holder.

2. Turn the bulb holder slightly

counterclockwise and pull straight off.

3. Insert new bulb, place bulb holder over

bulb and turn slightly clockwise to lock it

in place.

4. Screw lens holder back on.

FLASHLIGHT BATTERY REMOVAL

(FOR RECYCLING)

Before attempting to disassemble the

flashlight, turn it on and leave it on until

the light goes completely out to ensure a

complete discharge of the batteries. Using

a phillips screwdriver, remove the screws

in the flashlight housing as shown in

figure F. Lift the batteries out and pull off

the terminal clips (figure G). See “Service

Information” for battery replacement.

E

D

633374-00,02 SS925 1/11/06 10:52 AM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Commentaires sur ces manuels

Pas de commentaire