14
E N G L I S H
ASSEMBLY
Before attempting any of the following
operations, make sure that the tool is
switched off and unplugged and that the
disc has stopped rotating.
Removing and refitting of the guard
Never use the tool without the guard,
except when sanding.
Removing (fig. B)
This tool is fitted with a guard. For sanding only,
you can remove the guard as follows.
Remove the outer flange, disc and inner flange
as described below.
Use a screwdriver to remove the screws (6).
Remove the flange (7), guard (4) and spring
washer (8). Store these parts carefully.
Refitting (fig. C)
Place the tool on a table, with the spindle (9)
facing up.
Place the spring washer (8) over the spindle
and locate it on the shoulder (10).
Place the guard onto the tool as shown.
Place the flange (11) over the spindle with the
protruding pips towards the guard. Make sure
that the holes in the flange align with the screw
holes.
Secure the flange with the screws (6). Make sure
that the screws are fully tight and that the guard
can be rotated.
Fitting the side handle (fig. A)
Always use the side handle.
Screw the side handle (2) into one of the
mounting holes in the tool.
Fitting and removing grinding or cutting discs
(fig. A, D - G)
Always use the correct type of disc for
your application. Always use discs with the
correct diameter and bore size (see
technical data).
The maximum thickness for grinding discs
is 6 mm, for cutting discs 3.5 mm.
Fitting
If it has been removed, fit the guard as described
above.
Place the inner flange (12) onto the spindle (9)
as shown (fig. D). Make sure that the flange is
correctly located on the flat sides of the spindle.
Place the disc (5) onto the spindle (9) as shown
(fig. E). If the disc has a raised centre (13),
make sure that the raised centre faces the
inner flange.
Make sure that the disc locates correctly on the
inner flange.
Place the outer flange (14) onto the spindle.
When fitting a grinding disc, the raised centre
on the outer flange must face towards the disc
(A in fig. F). When fitting a cutting disc,
the raised centre on the outer flange must face
away from the disc (B in fig. F).
Keep the spindle lock (3) depressed and
tighten the outer flange using the two-pin
spanner (15) (fig. A & G). Make sure that the
outer flange is fitted correctly for the type of
disc used and that the disc is clamped tightly.
Removing
Keep the spindle lock (3) depressed and
loosen the outer flange (14) using the two-pin
spanner (15) (fig. A & G).
Remove the outer flange (14) and the disc (5).
Fitting and removing sanding discs (fig. A, H & I)
For sanding, a backing pad is required. The backing
pad is available from your Black & Decker dealer
as an accessory.
(8 pages)
(31 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels