Black & Decker BDH1720SM Manuel d'instructions Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
ATTACHING A CLEANING PAD - Fig. D
Replacement cleaning pads are available from
your Black & Decker dealer (cat. no. SMP20).
Place a micro-fiber cleaning pad (6) on the
floor with the ‘hook & loop’ side facing up.
Raise the steam mop off the resting mat
(7) and press it down onto the cleaning pad
(6). You are now ready to steam clean and
sanitize your floor.
NOTICE: Always place the steam mop on
the resting mat (7) with the handle (4) in the
upright position when stationary and make sure
the steam mop is turned off when not in use.
REMOVING A CLEANING PAD - Fig. E
CAUTION: Always wear suitable shoes
when changing the cleaning pad on your
steam mop. Do not wear slippers or
open-toed footwear.
Return the handle (4) to the upright position
and turn the steam mop ‘OFF’.
Place the steam mop on the resting mat and
wait until it cools down. (approximately five
minutes)
Place the front of your shoe onto the cleaning
pad removal tab (13) and press down firmly.
Lift the steam mop up off the cleaning pad.
NOTICE:
Always place the steam mop on the resting mat (7) with the handle (4) in the
upright position when stationary and make sure the steam mop is turned off when not in use.
FILLING THE WATER TANK - Fig. F & G
This Steam Mop incorporates an anti-calcium system to help prolong the life of the system.
NOTICE: The water tank is conveniently
removable for easier use.
NOTICE: Fill the water tank with regular
tap water.
NOTICE: In areas of very hard water, the
use of de-ionized water is recommended.
WARNING: Do not overfill the tank.
Only fill to bottom of hole with water tank in
vertical position.
Ensure that the appliance is switched off
and the power cord is disconnected from the
power supply.
Place the steam mop on the resting mat (7)
with the handle (4) in the upright position.
Remove the water tank (3) by pulling it
upwards.
• Open the filler cap (14) by lifting it up.
Fill the water tank (3) with water to the bottom
of the hole with tank in vertical position.
Close the filler cap (14).
Re-install the water tank onto the steam
mop body (11) and ensure it is firmly seated.
NOTICE: Always empty the water tank
after use.
5
F
G
D
E
Vue de la page 4
1 2 3 4 5 6 7 8 9 10 ... 31 32

Commentaires sur ces manuels

Pas de commentaire