Black & Decker BWE18A Manuel d'utilisateur Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 17
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
AIRCONDITIONERUSE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
iMPORTANT:
- If you turn off the air conditioner, wait at least 3 minutes before
turning it back on. This keeps the air conditioner from blowing a
fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the Cool mode when
outside temperature is below 61°F (16°C). The inside evapora-
tor coil will freeze up, and the air conditioner will not operate
properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Energy SaveriFan runs only when cooling is needed. Press
SPEED to select High, Med or Low fan speed.
Because the fan does not circulate the room air continuously,
less energy is used, but the room air is not circulated as often.
Dehum--Dries the room. The air conditioner automatically
selects the temperature. Fan runs on Low speed only.
NOTE: Dry mode should not be used to cool the room.
D_Y
0 ENER6Y
SAVER
0 CA.
1. Remove the clear plastic film from the control panel.
2. Press POWER to turn on the air conditioner. The Power
indicator light will turn on.
NOTE: After 5 seconds, display will show the current room
temperature.
3. Select mode. See "Mode."
4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."
Mode
1. Press MODE until you see the indicator light glow for the de-
sired setting.
2. Choose Fan, Cool, Energy Saver or Dry.
Fan--Only the fan runs. Press SPEED to select High, Med
or Low fan speed. The display shows the current room
temperature.
Cool--Cools the room. Press SPEED to select High, Med
or Low fan speed. Press the TEMP/TIME up or down
arrow button to adjust the temperature.
Fan Speed
NOTE: In Dry mode, the Speed button will not operate.
1. Press SPEED until you see the indicator light glow for
the desired setting.
2. Choose High, Med or Low.
High--for maximum cooling
Med--for normal cooling
Low--for minimum cooling
0 HIGH
_J_ ME.
LOW
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Commentaires sur ces manuels

Pas de commentaire