Black & Decker JUS500IB Manuel d'instructions télécharger pdf (Page 5)

Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting

(shorting can result in injury or fire).

TROUBLESHOOTING

Problem Solution

Unit Fails to Jump-Start

• Make sure unit’s power switch is in the ON position.

• Check that Jump-Starter has a full charge. Recharge unit if necessary.

• Make sure a proper polarity cable connection has been established.

• Leave charger plugged in and keep unit on charge for 24-48 hours.

USB Power Port will not power

appliance

• Make sure the

USB Charging Port ON/OFF Pushbutton

is in the ON

position.

• Check that Jump-Starter has a full charge. Recharge unit if necessary.

LED Area Light does not come on

• Make sure the LED Area Light ON/OFF button is in the ON position

• Check that Jump-Starter has a full charge. Recharge unit if necessary.

Portable Inflator will not inflate

• Make sure the Inflator Power Switch is in the ON position.

• Check that Jump-Starter has a full charge. Recharge unit if necessary.

• Make sure connector is pushed to valve stem and thumb latch is

closed when attempting to inflate tires; or nozzle (adapter) is securely

inserted into connector (chuck) on all other inflatables.

LED AREA LIGHT

The area light is controlled by the Area Light Power Switch on the front panel of the unit. Make sure the lamp is

turned OFF when the unit is being recharged or stored.

PORTABLE INFLATOR

The built-in 12 volt DC inflator is the ultimate inflator for all vehicle tires, trailer tires and recreational inflatables.

Three different sized nozzles are supplied. Each nozzle will clip on the end of the standard tire valve connector

located at the free end of the inflator hose. The inflator nozzles are stored inside the storage hatch on the top of

the unit. The inflator hose with tire fitting is stored in a retaining channel on the bottom of the unit. The ON/OFF

Switch is located on the front of the unit. The inflat

or can operate long enough to fill up to 3 average sized tires

before the battery must be recharged.

The inflator may be used by removing the air hose from the storage hatch and if required, fitting an appropriate

nozzle to the air hose. An ON/OFF switch located on the front of the unit controls the power to the inflator and the

gauge light. Refer to the “Controls and Indicators” section on page 5 for locations of inflator hose and nozzle

storage hatch. Return hose to the storage compartment after use.

WARNING: BURST HAZARD

• The inflator is capable of inflating up to 120 pounds per square inch (psi) pressure. To avoid over-inflation,

carefully follow instructions on articles to be inflated. Never exceed recommended pressures. Bursting articles

can cause serious injury.

• Always check pressure with the pressure gauge.

• Never leave the inflator unattended while in use.

CAUTION: RISK OF PROPERTY DAMAGE

Do not operate inflator continuously for extended periods of time (approximately 10 minutes, depending on

ambient temperatures), as it may overheat. In such event, inflator will automatically shut down. Im

mediately turn

OFF the Inflator Power Switch. Restart after a cooling down period of approximately 10 minutes.

Inflating Tires or Products With Valve Stems

1.Place connector (chuck) on valve stem.

2.Ensure connector is pushed on to valve stem as far as possible before closing thumb latch.

3.Make sure latch is secure.

4.Turn ON the Inflator Power Switch.

5.Check pressure with the pressure gauge.

6.When desired pressure is reached, open thumb latch and remove connector from valve stem.

7.Turn OFF Inflator Power Switch.

8.Allow unit to cool before storing away.

9.Store inflator hose and tire fitting in

storage compartment.

Inflating Other Inflatables Without Valve Stems

Inflation of other items requires use of one of the adapters (nozzles).

1.Select the appropriate nozzle, located on the inside back cover.

2.Insert appropriate adapter (i.e. needle) into connector (chuck) and close thumb latch.

3.Small items such as volleyballs, footballs, etc. inflate very rapidly.

4.Insert adapter (i.e., needle) into item to inflate to appropriate pressure.

5.Turn ON the Inflator Power Switch — inflate to desired pressure or fullness.

6.Remove adapter.

7.Switch the Inflator Power Switch OFF.

8.Recharge the unit before storing away.

CARE AND MAINTENANCE

BLACK DECKER ACCESSORIES

GARAGE ACCESSORIES

1 2 3 4 5

Commentaires sur ces manuels

Pas de commentaire

Black & Decker JUS500IB Manuel d'instructions Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Les démarreurs à distance Black & Decker JUS500IB