Black & Decker freewire Manuel d'instructions Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 17
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
11
CODE SEARCH BY BRAND
Lets you search for a code for a specific
Brand within the Code Library for a
particular manufacturer.
1. Turn on the device (TV, VCR, etc.) to
be controlled.
2. Press and quickly release the desired
mode button (TV, VCR, etc.).
3. Press and hold the SETUP button until
the Mode button stays on. You can
now release the SETUP button.
4. Press and release the numeric button
(0-9) corresponding to desired
Manufacturer (see table on separate
sheet). The green indicator blinks off
once.
NOTE: Pressing “0” performs a full
library search same as normal Code
Search Method on previous page.
5. Press the CHANNEL UP button ((or
POWER or PLAY (VCR only))
repeatedly until the device to be
controlled changes channel. The green
indicator blinks off with each button
press. If you accidentally overshoot the
code required, press the CHANNEL
DOWN button to backtrack through the
library until the device changes
channel. Pressing CHANNEL UP
changes direction to forward again.
6. Press and release MUTE to install the
code.
Brand Search Method entry is now
complete.
Note: When all codes under a Brand
have been searched the red indicator
flashes rapidly for 3 seconds.
2.
3.
4.
6.
5.
BRAND SEARCH TABLE
Look up your brand in the appropriate
column (TV, VCR, etc.). Look to see
what digit (1, 2, 3, etc.) applies to your
brand, and enter it in step 4 of “Code
Search by Brand” on separate sheet.
CODE IDENTIFICATION FEATURE
The Code Identification Feature allows
you to identify the three digit library code
stored under your device key.
For example, if you want to find out what
three digit code is stored under your TV
device key, follow the six steps below:
1. Press and quickly release the desired
mode button (TV, VCR, etc.).
2. Press and hold the SETUP button until
the Mode button stays on. You can
now release the SETUP button.
3. Press and release the SETUP button.
The green indicator blinks off.
4. To find the first digit for the code stored
under the mode key pressed in step 2,
press each numeric key from 0-9 in
turn. When the green indicator blinks
off the number you pressed is the first
digit for the code you are searching for.
5. To find the second digit, repeat step 4,
this time when the green indicator
blinks off this is the second digit.
6. Repeat step 4 again to find the third
digit.
1.
2,3.
4,5,6.
CODE ENTRY , cont.
622715-00 Master Remote manual 2/4/04 9:17 AM Page 11
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Commentaires sur ces manuels

Pas de commentaire