Black & Decker CS718-AE Manuel d'instructions télécharger pdf (Page 7)

To Remove the Blade

Adjust the depth of cut of the saw to

maximum.

Fully retract the lower guard.

With the lower guard fully open, depress the

spindle lock button and rotate the blade until

the spindle lock engages the spindle.

With the spindle lock button firmly depressed,

rotate the locking screw with the hex spanner

in an anti-clockwise direction.

Fully remove the screw and small washer.

Fully remove the outer flange and the saw

blade.

To Fit the Blade

Ensure the inner flange is fitted to the saw and

is free of any sawdust/ dirt etc.

With the lower guard fully retracted fit the blade

ensuring the arrow on the blade is in the same

direction as the arrow on the saw cover.

Ensure the blade is sitting flat on the inner

flange.

Fit the outer flange ensuring the flange is clean.

Fit the blade locking screw and washer and

engage the spindle lock. Tighten the locking

screw by rotating with the hex spanner in a

clockwise direction.

Replacement Blades

The CS718 Circular Saw is designed to fit the

following blade.

Blade 184mm (7

1

/4”)

Bore diameter 20mm

No load speed (min) 4800 RPM

obtained between the tooth of the cutting blade

and the inner edge of the parallel fence.

To ensure the correct setting, always make a

test cut on a scrap piece of timber to ensure

the parallel fence has been correctly set to the

measurement you require.

Setting the Bevel Adjustment

Your circular saw can cut angles up to 45 Deg.

To adjust the angle of your circular saw

proceed as follows:

Remove the plug of the saw from the electricity

supply.

Unlock the bevel adjustment by turning the

lock lever clockwise. Move the saw around

the bevel scale until the desired angle is

indicated. Tighten the bevel lock by rotating

anti-clockwise. To ensure the correct setting,

always make a test cut on a scrap piece of

timber. Make any fine adjustments to the angle

if necessary.

Changing the Blade

Before fitting any blade to the circular saw

ensure the max safe working speed of the

blade is above 4800RPM.

Remove the plug of the saw from the electricity

supply. Never attempt to change the blade

while the circular saw is plugged into the

electricity supply.

PIC G

Outer Flange

Saw Blade

hex head bolt

7

1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire