Black & Decker CS718-AE Manuel d'instructions télécharger pdf (Page 6)

A scale referring to the depth of cut is provided

as a guide. It is located between the top guard

and the rear handle.

Note, the scale is a guide only and where an

accurate depth of cut is required, the actual

depth of cut should be measured with a rule.

After the desired setting is achieved, lock the

depth of cut adjustment by pushing the depth

of cut locking lever downwards.

Where the saw blade is required to cut fully

through the work piece, the blade should be

set to a depth of cut 3 - 5 mm greater than the

work piece.

Fitting and Adjusting the Parallel

Fence

Your CS718 Circular Saw includes a parallel

fence. This assists in the sawing of a straight

line, parallel to the edge of the work piece.

To fit and adjust the parallel fence proceed as

follows:

Remove the plug of the saw from the

electricity supply.

Loosen the parallel locking screw at the front of

the saw shoe.

Slide the parallel fence into the slot under the

locking screw.

Slide the parallel fence towards the cutting

blade until the desired measurement is

Additional Safety Instructions

For Circular Saw

Warning! The use of any accessory or

attachment, other than recommended in

this instruction manual, may present a risk

of personal injury.

Warning! Your saw is designed for

use with wood cutting blades with a max

operating speed above 4800 RPM.

Warning! Do Not use blades with a

Max operating speed below this speed.

Do not use saw blades which are deformed

or cracked.

Do not use saw blades made from High

Speed Steel.

Do not use saw blades which do not

comply with the characteristics specified

within this manual.

Do not stop the saw with lateral pressure on

the blade.

Do not lock the moveable guard in the open

position.

Ensure the moveable guard operates freely

without jamming.

Always ensure the retraction mechanism of

the guard operates correctly prior to using

the saw each time.

Always remove the plug of the saw from

the mains supply before making any

adjustments or maintenance to the saw.

Preparing Your Saw

Setting the Depth of Cut.

Remove the plug of the saw from the electricity

supply.

Unlock the depth of cut lock adjustment by

lifting the depth of cut locking lever.

The depth of cut can now be adjusted by lifting

the rear section of the saw body.

PIC C

Depth of Cut

Scale

Depth of Cut

Lever

6

1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire