timber require special attention during cutting
operation to prevent kickback.
Line Guide
The right side of the notch in the front of the
shoe is the guide for straight 90 degree cuts.
The left side of the notch is for 45 degree
bevel cuts. The cutting guide notch gives an
approximate line of cut since different blade
types and thickness alter the line cut. Always
make sample cuts in scrap timber to obtain the
actual line cut. To minimize splintering, cut the
good side down.
General Cuts
When starting a cut always hold the saw
handle with one and and the front handle with
the other. Never force the saw but maintain a
light and continuous pressure.
After completing the cut, allow the saw to
come to a complete stop. When cutting is
interrupted, resume cutting by allowing the
blade to reach full speed and then re-entering
the cut slowly.
When cutting across the grain, the fibres of
the wood have a tendency to lift and tear.
Moving the saw slowly minimises this effect.
Pocket Cuts
Disconnect the plug from the power supply
before making any adjustments. Set the depth
adjustment based on the thickness of the
material to be cut. Tilt the saw forward with
the cutting guide notch on the line drawn for
the cut. Raise the lower guard by using the lift
lever. With the blade barely above the material
to be cut, start the saw and allow the blade to
come to full speed. Gradually lower the blade
into the material being cut using the front end
of the shoe as a pivot point. When the blade
starts cutting, release the lower guard. When
the shoe is resting flat on the surface being
cut, proceed cutting in a forward direction to
the end of the cut. Allow the blade to come to a
full stop before removing it form the cut. Never
pull the saw backward since the blade will
climb out of the cut and kick back will occur.
Turn the saw around and finish the cut in a
normal manner, sawing forward. Use a jigsaw
or a handsaw to finish the cut in the corners, if
required.
Maintenance
1. All bearings are sealed. They are lubricated
for life and need no further maintenance.
2. The brushes are designed to give you
several years of use. If they ever need
replacement return the tool to the nearest
service centre for repair.
Important
To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment including
brush inspection and replacement) should be
performed by authorised service centres or
other qualified service organisations, always
using identical replacement parts.
Service Information
Black & Decker offers a full network of
company owned and authorized service
locations throughout the country. All Black &
Decker Service Centers are staffed with trained
personnel to provide customers with efficient
and reliable power tool service. Whether you
need technical advice, repair, or genuine
factory replacement parts, contact the Black
& Decker location nearest you. To find your
local service location, refer to the yellow page
directory under “Tools—Electric” or call:
U.A.E on 971-4-7028234
10
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels