Black & Decker LI3100 Manuel d'instructions télécharger pdf (Page 14)

ENGLISH

these instructions to operate the power tool. Power

tools are dangerous in the hands of untrained users.

e. Maintain power tools. Check for misalignment or

binding of moving parts, breakage of parts and any

other condition that may affect the power tools

operation. If damaged, have the power tool repaired

before use. Many accidents are caused by poorly

maintained power tools.

f. Keep cutting tools sharp and clean. Properly maintained

cutting tools with sharp cutting edges are less likely to

bind and are easier to control.

5. Battery tool use and care

a. Recharge only with the charger specified by the

manufacturer. A charger that is suitable for one type of

battery pack may create a risk of fire when used with

another battery pack.

b. Use power tools only with specifically designated

battery packs. Use of any other battery packs may

create a risk of injury and fire.

c. When battery pack is not in use, keep it away from

other metal objects, like paper clips, coins, keys, nails,

screws, or other small metal objects, that can make a

connection from one terminal to another. Shorting the

battery terminals together may cause burns or a fire.

d. Under abusive conditions, liquid may be ejected from

the battery; avoid contact. If contact accidentally

occurs, flush with water. If liquid contacts eyes,

a dditionally seek medical help. Liquid ejected from the

battery may cause irritation or burns.

6. Service

a. Have your power tool serviced by a qualified repair

person using only identical replacement parts. This

will ensure that the safety of the power tool is maintained.

7. Electrical safety

Your charger is double insulated; therefore no earth

wire is required. Always check that the mains voltage

corresponds to the voltage on the rating plate.

Warning! If the power cord is damaged, it must be

replaced by the manufacturer, authorized

Black & Decker Service Center or an equally qualified

person in order to avoid damage or injury. If the power

cord is replaced by an equally qualified person, but

not authorized by Black & Decker, the warranty will

not be valid.

8. Labels on tool

The label on your tool may include the following symbols:

Warning! Additional safety warnings for screwdrivers and

impact wrenches.

 Hold power tool by insulated gripping surfaces when

performing an operation where the fastener may

contact hidden wiring or its own cord. Fasteners

contacting a "live" wire may make exposed metal parts of

the power tool "live" and shock the operator.

 Wear ear protectors with impact wrenches. Exposure

to noise can cause hearing loss.

 Use auxiliary handles supplied with the tool. Loss of

control can cause personal injury.

 Use clamps or another practical way to secure and

support the workpiece to a stable platform. Holding the

work by hand or against your body leaves it unstable and

may lead to loss of control.

 Before driving fasteners into walls, floors or ceilings, check

for the location of wiring and pipes.

 This tool is not intended for use by persons (including

children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction

concerning use of the appliance by a person responsible

for their safety. Children should be supervised to ensure

that they do not play with the appliance.

 The intended use is described in this instruction manual.

The use of any accessory or attachment or performance

of any operation with this tool other than those

recommended in this instruction manual may present a

risk of personal injury and/or damage to property.

ADDITIONAL POWER TOOL

SAFETY WARNINGS

ead Instructions Manual

se Eye Protection

Use Ear Protection

V ........... Volts

........... Amperes

Hz ......... Hertz

W........... Watts

min........ minutes

....... Alternating Current

........ Direct Current

.......... No-Load Speed

....... Class II Construction

....... Earthing Terminal

........ Safety Alert Symbol

.../min.... Revolutions or

Reciprocation

per minute

1 2 ... 9 10 11 12 13 14 15 16 17

Commentaires sur ces manuels

Pas de commentaire

Black & Decker LI3100 Manuel d'instructions Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Tournevis électriques Black & Decker LI3100