Black & Decker Fire Storm 90521841 Manuel d'instructions Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
7
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
parts.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unit will not start. • Battery not charged. • Check battery charging
requirements.
• Battery will not charge. • Charger not plugged in. • Plug charger into a
working outlet. Refer to
“Important Charging
Notes” for more details.
• Check current at
receptacle by plugging in
a lamp or other appliance.
• Check to see if
receptacle is connected to
a light switch which turns
power off when you turn
out the lights.
• Surrounding air temperature Move charger and tool
too hot or too cold. to a surrounding air
temperature of above 40
degrees F (4,5°C) or
below 105 degrees F
(+40,5°C).
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
Accessories
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could be
hazardous.
Battery Removal
Before attempting to disassemble this tool, turn it on and run it in either direction until it
stops to ensure a complete discharge of the batteries. Using a phillips screwdriver,
remove the screws in the product housing and lift the housing half from the tool.
Disconnect the terminal clips from the batteries and lift the batteries out. See “Service
Information” for battery replacement.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the nickel-
metal hydride battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by
Black & Decker. In some areas, it is illegal to place spent nickel-metal hydride
batteries in the trash or municipal solid waste stream and the RBRC program provides an
environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent nickel-metal
hydride batteries. Help protect our environment and conserve natural resources by
returning the spent nickel-metal hydride battery to an authorized Black & Decker service
center or to your local retailer for recycling. You may also contact your local recycling
center for information on where to drop off the spent battery, or call 1-800-8-BATTERY.
90521841 FSD600 6/20/07 10:34 AM Page 7
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Commentaires sur ces manuels

Pas de commentaire