ENGLISH
9
(Original instructions)
u Before measuring for the proper viscosity, stir the material
thoroughly.
u Dip the viscosity cup (13) into the material being sprayed
u With the viscosity cup (13) held over the material con-
tainer, measure the amount of time it takes for the stream
stream out of the bottom of the viscosity cup (13) (2
the thinning table for information on the thinning required
for different materials.
u If material needs thinning, add the appropriate liquid thin-
ning material recommended by the manufacturer.
u It is possible to spray latex paint with this unit, however,
the required thinning may exceed material manufacturer's
recommendation. Thin latex paint so that it runs through
viscosity cup (13) in under 2 minutes. The operator should
project when spraying a material that requires more than 2
minutes to run through the viscosity cup (13).
Hints for optimum use
Preparation tips
u Always stir and strain the material thoroughly before use.
u With any spraying job you should always ensure that
you have properly prepared the surface to get the best
grease. Lightly pressure wash decks or exterior surfaces
and ensure that they are dry before spraying.
u Even though HVLP sprayers have very little overspray,
it is recommended that you mask all edges and other
anything else in the spraying area that you wish to remain
untouched.
u Skin that forms on the top of paint can clog the sprayer.
Remove skin before mixing. Strain with a funnel with a
that could clog system.
u Before starting have gloves, paper towels, rags etc. avail-
able for unexpected spills.
u Practice spraying on a piece of scrap material such as
cardboard to test your spray pattern and become familiar
u Ensure surface to be sprayed is free of dust, dirt, and
grease.
u Ensure spray area is clean and free of dust that could be
blown onto newly sprayed surfaces.
u Cover any areas not intended to be sprayed.
u Always spray from a minimum of 25mm to a maximum of
u A commonly used method for spraying a large surface
is the “crisscross” pattern. This is done by spraying in
horizontal strips and then crossing over these strips with
vertical strips.
u To get an even spray distribution, always keep your arm at
-
u Maintain smooth and consistent speed which will help
avoid inconsistencies. Begin spraying after the pass has
begun and release trigger before stopping the pass.
u Avoid spraying too heavily in any one area. Several lighter
coats are better than one heavy coat which can lead to
knob regulates the amount of liquid that can be sprayed.
liquid. Turning the knob counterclockwise decreases the
brush on hand to smooth them out.
u Turn the power unit off and place the sprayer in the built-in
dock of the power unit when not spraying for any length of
time.
Maintenance and cleaning
Your Black & Decker corded appliance has been designed to
operate over a long period of time with a minimum of main-
tenance. Continuous satisfactory operation depends upon
proper appliance care and regular cleaning.
Material compatibility table
MATERIAL
LATEX
ENAMEL
OIL BASED PRIMERS
OIL BASED VARNISHES
CLEAR STAINS
SEMI- TRANSPARENT STAINS
COMPATIBLE
YES
YES
YES
YES
YES
YES
Important Note:
Ensure the material used passes viscosity test.
Using the viscosity cup to test, full cup should be emptied
within two (2) minutes.
(112 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels