Black & Decker BDPH200 Manuel d'instructions télécharger pdf (Page 7)

PREPARATION TIPS

• Always stir and strain the material thoroughly before use.

• With any spraying job you should always ensure that you have properly prepared the surface to get the best finish.

That is, all surfaces are free from dust, dirt, rust and grease. Lightly pressure wash decks or exterior surfaces and

ensure that they are dry before spraying.

• Even though HVLP sprayers have very little overspray, it is recommended that you mask all edges and other areas

and use drop cloths to protect your floors and anything else in the spraying area that you wish to remain untouched.

• Skin that forms on the top of paint can clog the sprayer. Remove skin before mixing. Strain with a funnel with a filter

attached or through hosiery to remove any impurities that could clog system.

• Before starting have gloves, paper towels, rags etc. available for unex-

pected spills.

FILLING THE CANISTER - (FIGURE D)

• Check to make sure that the canister is completely screwed onto the

sprayer.

• Lay the sprayer on its side with the canister side lid facing up.

• Unscrew the lid on the side of the canister.

• Pour the properly thinned and strained material to be sprayed into the

side fill canister (figure D). TIP: Use the mixing bucket provided to

pour material from the original material container into the side fill

canister.

• Clean any residual liquid from the threads or sides of the canister and

sprayer.

• Starting the threads evenly, screw the lid completely onto the side fill

canister. Check the lid to make sure it is threaded on squarely and

completely before picking up the sprayer.

OPERATION

MATERIAL FLOW ADJUSTMENT

Set the material volume by turning the

material adjustment knob on the trigger of the

sprayer.

• For maximum material flow, thread knob all

the way in as shown in figure E.

• For minimum material flow, thread knob all

the way out as shown in figure E1.

The flow indicator on the side of the sprayer

moves forward (minimal liquid flow) and

backward (maximum liquid flow) as the trigger

is depressed.

TIP: Always test the spray pattern on scrap cardboard or similar material first. Begin with the material

adjustment knob on the highest flow setting (threaded all the way in). If less flow is desired, dial the material

adjustment knob out. Heavier, thicker materials should be sprayed with the knob dialed farther in. Thinner

materials should be sprayed with the knob dialed farther out.

THINNING TABLE

SPRAY MATERIAL RUNOUT TIME

lear and semi-transparent stains and sealers No thinning required

Oil based primers, varnishes and polyurethane (Less than 2 minute runout)

Solid color water based stains May require thinning

Water based or latex paints (More than 2 minute runout)

Note: Not recommended for textured paint

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Black & Decker BDPH200 Manuel d'instructions Page 7

Commentaires sur ces manuels