Black & Decker NPP2018 Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8
Preparing Your Pole Trimmer for Use
WARNING: Read and understand all instructions. Failure to
follow all instructions listed below may result in electric shock, fire
and/or serious personal injury.
Installing and Removing Saw Chain
WARNING: Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle
before performing the following operations. Failure to do this
could result in serious personal injury.
CAUTION: Sharp moving blade. Always wear protective
gloves when installing or removing the chain. The chain is sharp
and can cut you when it is not running.
Place the saw on a firm surface.
Rotate the two allen head screws
counterclockwise with the wrench
provided as shown in figure 2.
Remove sprocket cover, bar clamp,
and allen head screws.
To remove the chain, rotate the screw
in the front of the housing using the
flat screwdriver end of the wrench as
shown in figure 3. Turning the screw
counterclockwise allows the guide
bar to recede and reduces the
tension on the chain so that it may be
removed.
Lift the worn chain out of the groove
in the guide bar.
Flip guide bar over.
To replace the chain, check to make
sure that the slot in the guide bar is
over the two location pins shown in
figure 3A and that the hole below the
slot is located over the adjustment
pin.
Features
Before using your Pole Saw familiarize yourself with all operating and
safety features.
5
4
3
2
1
11
10
9
8
7
6
A. Handle Module
B. Center Extension
C. Saw Head Module
1. Trigger Switch
2. Lock Button
3. Battery
4. Foam Gripper
5. Threaded Pole
6. Threaded Sleeve
7. Center Extension Pole
8. Sprocket Cover (other side)
9. Allen Head Screws (other side)
10. Guide Bar
11. Saw Chain
12. Scabbard
13. Allen Wrench
14. Oil Bottle
6
A
B
C
12
13
14
2
3
3A
LOCATING PINS
ADJUSTMENT PIN
Switch - A device that when operated will complete or interrupt an
electrical power circuit to the motor of the chain saw.
Switch Lockout - A movable stop that prevents the unintentional
operation of the switch until manually actuated.
Trimming (Pruning) - Process of cutting limbs from a tree.
Undercut - An upward cut from underside of a log or limb.This is done
while in normal cutting position and cutting with top of guide bar.
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Commentaires sur ces manuels

Pas de commentaire