Black & Decker NPP2018 Manuel d'utilisateur télécharger pdf (Page 6)

capacity than 18 gauge. When using more than one extension to

make up the total length, be sure each extension contains at least

the minimum wire size.

CHART FOR MINIMUM WIRE SIZE (AWG) OF EXTENSION CORDS

NAMEPLATE RATING AMPS – 0 – 10.0

Total Extension Cord

Length (ft) 0-25 26-50 51-100 101-150

(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)

Wire Gauge 18 16 16 14

9. Use only the supplied charger when charging your unit. The use

of any other charger could damage the battery pack or create a

hazardous condition.

10. Use only one charger when charging.

11. Do not attempt to open the charger or the unit. There are no

customer serviceable parts inside. Return to any authorized Black

& Decker service center.

12. DO NOT incinerate battery packs even if they are severely

damaged or completely worn out.

13. Do not incinerate the batteries. They can explode in a fire. A small

leakage of liquid from the battery cells may occur under extreme

usage, charging or temperature

conditions. This does not indicate a failure. However, if the outer

seal is broken and this leakage gets on your skin:

a. Wash quickly with soap and water.

b. Neutralize with a mild acid such as lemon juice or vinegar.

c. If the battery liquid gets in your eyes, flush them with clean water

for a minimum of 10 minutes and seek immediate medical

attention. MEDICAL NOTE: The liquid is a 25-35% solution of

potassium hydroxide.

IMPORTANT CHARGING SAFETY

INSTRUCTIONS

CHARGING PROCEDURE

THE BATTERY PACK IS NOT FULLY CHARGED AT THE

FACTORY. CHARGE BATTERY PACK FOR AT LEAST 9 HOURS

BEFORE USE.

The charger is designed to use standard household 120 volt 60 Hz

power.

1. Plug the charger into any standard 120 Volt 60 Hz electrical

outlet. NOTE: Do not charge by means of an engine

generator or DC power source. Use only 120V AC.

2. Slide the charger onto the battery as

shown in figure 1 and let the battery

charge initially for 9 hours. After the

initial charge, under normal usage, your

battery should be fully charged in 6 to 9

hours.

2a) During charging the green LED will

appear.

2b) When charging is complete the green

LED will go off.

3. Unplug charger, and remove the battery pack. Place the battery

pack into the tool until it “clicks” into place.

NOTE: To remove the battery pack, press down on the release

button on the back of the battery pack and slide out.

IMPORTANT CHARGING NOTES

1. After normal usage, your battery pack should be fully charged in

6 to 9 hours. If the battery pack is run-down completely, it may

take up to 9 hours to become fully charged. Your battery pack

was sent from the factory in an uncharged condition. Before

attempting to use it, it must be charged for at least 9 hours.

2. DO NOT charge the battery pack in an air temperature below

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Black & Decker NPP2018 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Black & Decker NPP2018