Black & Decker NPP2018 Manuel d'utilisateur télécharger pdf (Page 10)

Joining Center Extension to Saw Head Module and

Handle Module

Adding the extension (B) to the handle module (A) and saw head

module (C) creates a Pole Saw that is approximately 9 foot in length

as shown in figure 13.

To attach the middle module to the handle module and saw head

module:

1. Align the groove on the outside of the

coupling end of the handle module (A)

with the tongue on the inside of the

coupling end of the center extension (B).

See figure 14. Push the two sections

completely together.

2. Slide the threaded sleeve (6) (figure

15) on the center extension down as far

as possible and rotate the sleeve

clockwise until it stops and completely

covers the orange threads as shown in

figure 16.

3. Repeat steps 1 and 2 above to attach

the saw head module to the center

extension.

WARNING: Always check to make

sure that the sleeve is completely

threaded on and that the orange threads are no longer visible.

Not threading the sleeve completely on could result in the modules

becoming disconnected creating a hazardous condition.

Periodically check the connections to insure that no orange threads

are visible.

Groove

Assembly

Joining Saw Head Module to 18V Handle Module

WARNING: Sharp moving blade. To prevent accidental

operation, insure that battery is disconnected from the handle

and that the protective scabbard is in place on the chain before

performing the following operations. Failure to do this could result

in serious personal injury.

The three modules which make up the 18V Pole Saw are keyed to

insure correct assembly. If a module does not smoothly attach to

another do not force fit.

Combining the handle module (A) to the saw head module (C)

creates a pole saw that is approximately 6 foot in length as shown in

figure 9.

To attach the handle module to the saw head module:

1. Align the groove on the outside of the coupling end of the handle

module (A) with the tongue on the

inside of the coupling end of the saw

head module (C). See figure 10. Push

the two sections completely together.

2. Slide the threaded sleeve (6) figure 11

on the saw head module down as far as

possible and rotate the sleeve clockwise

until it stops and completely covers the

orange threads as shown in figure 12.

WARNING: Always check to make

sure that the sleeve is completely

threaded on and that the orange

threads are no longer visible. Not

threading the sleeve completely on

could result in the modules becoming

disconnected creating a hazardous

condition. Periodically check the

connections to insure that no orange

threads are visible.

Groove

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Black & Decker NPP2018 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Black & Decker NPP2018