Black & Decker PV9605N Manuel d'instructions télécharger pdf (Page 8)

ENGLISH

If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service

Centre in order to avoid a hazard.

Warning! Never attempt to replace the charger unit with

a regular mains plug.

Safety of others

X This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning the use of the appliance by

a person responsible for their safety.

X Children should be supervised to ensure that they

do not play with the appliance.

Symbols on the charging base

Features

1. Release latch for container door

2. Container door

3. Collector lock button

4. Two-speed on/off switch

5. Filter cleaning wheel

6. Charging indicator

7. Charging base

8. Dust collector extension

9. Dust collector

Fig. D

10. Crevice tool (optional, see packaging)

11. Brush tool (stored in underside of appliance)

Installation

Fitting the charging base to the wall (fig. A)

The charging base can be placed on a work top or fitted to

the wall to provide a convenient storage and charging point

for the appliance.

When fixing to a wall, make sure that the fixing method is

suitable for the wall type and is appropriate to the weight

of the appliance.

Assembly

Adjusting the dust collector (fig. B & C)

X The dust collector (9) is stored under the appliance. To

adjust for use, lift the appliance from the charging base.

X Press the collector lock button (3) and rotate the dust

collector to the required position.

X Release the collector lock button to lock the dust

collector in position.

X The dust collector can be extended by pulling the dust

collector extension (8) until it locks into position.

X The extension can be retracted by pressing the

button (13) and pushing the extension back into the

dust collector.

X The dust collector should be returned to the storage

position under the appliance after use and while

charging the appliance.

Fitting the accessories (fig. D)

These models are supplied with some or all of the following

accessories:

X A crevice tool (10) for confined spaces.

X A brush tool (11) for furniture and stairs.

To fit an accessory, proceed as follows:

X Take the accessories from the appliance.

X Insert the appropriate accessory into the front of the

appliance.

Use

X Before first use, the battery must be charged for at least

16 hours.

X Place the appliance on the charging base whenever it is

not in use.

Charging the battery (fig. E)

X Make sure that the appliance is switched off. The

battery will not be charged with the on/off switch in the

on position.

X Place the appliance on the charging base (7) as shown.

X Plug in the charger. Switch on at the mains.

The charging indicator (6) will be lit.

X Leave the appliance to charge for at least 16 hours.

Your charging base is double insulated; therefore

no earth wire is required.

Fail-safe isolating transformer. The mains supply is

electrically separated from the transformer output.

The charger automatically shuts off if the ambient

temperature becomes too high. As a consequence

the charger will be inoperable. The charging base

must be disconnected from the mains supply and

taken to an authorised service centre for repair.

The charging base is intended for indoor use only.

Surfaces may become hot during use and during

the cool down period.

130

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 75 76

Commentaires sur ces manuels

Pas de commentaire

Black & Decker PV9605N Manuel d'instructions Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Aspirateurs portables Black & Decker PV9605N