Black & Decker BDPS200 Manuel d'utilisateur télécharger pdf (Page 9)

FLOW CONTROL SETTINGS

FLOW CONTROL KNOB - (FIGURE G)

The flow control knob regulates the amount of liquid that can be sprayed.

• Select low (1), medium (5) or high (9) on the flow control knob.

IP: Always test the spray pattern on scrap cardboard or similar material

irst. Begin with flow control knob on the highest flow setting. Heavier,

hicker materials should be sprayed on the higher setting closer to #9.

hinner materials should be sprayed on the lower setting closer to #1.

OPERATION

ON / OFF TRIGGER - (FIGURE H)

The sprayer is turned on and off by the trigger.

• To turn the sprayer on, squeeze the trigger.

• To turn the sprayer off, release the trigger.

WARNING: Risk of injury. Never point the sprayer at any part of the body.

Never pull the trigger while adjusting the spray setting.

DEVELOPING THE PROPER SPRAYING TECHNIQUE

• Practice spraying on a piece of scrap material such as cardboard to test your spray pattern and become familiar with

the speed settings flow control features of the sprayer.

• Ensure surface to be sprayed is free of dust, dirt, and grease.

• Ensure spray area is clean and free of dust that could be blown onto newly sprayed surfaces.

• Cover any areas not intended to be sprayed.

• Always spray from a minimum of 1 inch (25mm) to a maximum of 14 inches (355mm) (figure I). Optimal is usually

around 10 inches or use a paint stir stick as a reference.

• A commonly used method for spraying a large surface is the “crisscross” pattern. This is done by spraying in

horizontal strips and then crossing over these strips with vertical strips.

• To get an even spray distribution, always keep your arm at the same distance (figure I) from the surface you are

spraying and avoid moving your wrist (figure I1).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Pas de commentaire

Black & Decker BDPS200 Manuel d'utilisateur Page 9