Black & Decker KW800 Guide de l'utilisateur télécharger pdf (Page 9)

BENCH OPERATION

R9PLUS Dovetail Jig User Guide

Making The Beam

Chapter 1

1-19

The template will now be used to precisely position the pin

plates. Slightly loosen all pin plate screws

just enough so that

the pin plates can move side to side. Position the template on the

pin plates in the

⁄8"[9,5mm] position

. Set the sidestop to the

TD Max position

1-21

Gradually tighten the second pin plate screws

making

sure the template is not binding on the pins. Move the template

to the second position and repeat the procedure with the third

pin plate.

1-20 Clamp a square board against the sidestop and flush

under the template. Insert the shank of the No.80-8 bit into

the

⁄16"[8mm] hole in the template. Move the template and pin

plates laterally until the shank of the bit just touches the edge of

the board. Now tighten the first pin plate.

1-22

Optional Hold-down for Bench Use

Notch out the

ends of the beam in order to clamp beam assembly to a bench

and use in hand-held router mode.

■

Important: The beam may expand or contract with humidity changes. Use the

⁄8"[9,5mm]

holes to adjust the pin plates as required.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Pas de commentaire

Black & Decker KW800 Guide de l'utilisateur Page 9