Black & Decker KW800 Guide de l'utilisateur télécharger pdf (Page 8)

BENCH OPERATION

R9PLUS Dovetail Jig User Guide

Making The Beam

Chapter 1

REV 040314

5/16

7/8

5/16

dia. x 1/4

deep

1/2

[114mm]

[8mm]

[47mm]

[8mm x 6.35mm]

1-13 Turn the assembly upside down. Take a piece of the

predrilled sacrificial board and lay it flush on the template.

1-15 Place the clamping surface

against the beam

flush

against the sacrificial board. Be sure the clamp hole layout

marks

are next to the sacrificial board

. Screw the clamping

surface to the beam through the countersunk holes. If screwing

into a hardwood beam, first drill pilot holes in the beam.

1-17

Sidestop Positioning

Create layout lines as indicated

above for the sidestop

Note:

Be precise. Sidestop positioning

is very important.

1-14 Using the two

⁄16"[8mm] holes as drill guides, drill

two

⁄16"[8mm] holes through the beam. Attach the sacrificial

board at the left end with a ¼-20 machine screw and wing nut.

Then move the template to its second position and install the

second screw.

1-16

Clamp Holes Drill all

⁄

"[19mm] clamp holes

square

to the beam, through the clamping surface and beam. Next,

drill two holes (as per beam drawing),

⁄16"[8mm] diameter and

⁄16"[14mm] deep, for the table glide

(used for router table

operation only).

1-18 Using a Brad Point or Forstner bit, counter bore a

⁄16"[8mm] hole

⁄4"[6,35mm] deep for the sidestop hub.

Then, using a

⁄32"[2,5mm] bit, drill a pilot hole for the sidestop

mounting screw. Attach the sidestop to the beam with the

provided No.8 x 1

⁄4"[30mm] round head screw

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Black & Decker KW800 Guide de l'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Black & Decker KW800