Black & Decker KW800 Guide de l'utilisateur télécharger pdf (Page 11)

1111

“Outside” of board

“Inside” of board

“Either side“ of board

“Outside” of board (on other side of board)

“Inside” of board (on other side of board)

“Either side“ of board (on other side of board)

“This edge” against side stop

“This edge” against side stop (on other side of board)

Which Way Around Should the Board Go?

The following symbols/icons are used throughout this user guide.

They indicate which side of a board faces out (toward you, the

operator, when clamped in jig), which faces are in or out when

assembled, and which edge goes against the sidestop. Dashed line

icons indicate the other side of the board.

R9PLUS BENCH OPERATION

CHAPTER 2

Glossary of Symbols

2-3

Note: Because through dovetail pin and tail boards face

only one way, both side edges are (alternately) used against the

sidestop.

■

2-2 Box joint boards are clamped against the beam both “face

in” and “face out” for alternate end cuts. With box joints, the same

side edge always goes against the sidestop.

2-1

Icons such as the one above indicate which side of the board

faces out (toward you, the operator) when clamped in jig, and

which faces are in or out when assembled.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Black & Decker KW800 Guide de l'utilisateur Page 11