Black & Decker FSNS100 Manuel d'instructions télécharger pdf (Page 8)

USING THE TOOL

Complete all steps of PREPARING THE TOOL before using the tool.

This tool is shipped from the factory with a “single sequential actuation” trigger. To

fire, grip the tool firmly to maintain control, position nose of tool onto work

surface, push the tool firmly against work surface to depress safety (S) Fig. 28,

and squeeze trigger to fire a nail. Allow tool to recoil away from work surface as nail

is driven. This “single sequential actuation” method provides the most accurate

fastener placement.

Disconnect tool from air supply before performing

maintenance, clearing a jammed fastener, leaving work area, moving tool to

another location, or handing the tool to another person.

Clean and inspect tool daily. Carefully check for proper operation of trigger and

safety mechanism. Do Not use the tool unless both the trigger and the safety

mechanism are functional, or if the tool is leaking air or needs any other repair.

The depth to which a nail is driven is controlled by the depth adjustment knob (A) Fig.

29. The depth of drive is factory adjusted to a nominal setting. Test fire a fastener and

check depth. If a change is desired, rotate the adjustment knob (A) Fig. 29. The

adjustment knob has detents every

/4 turn. Rotate the knob (A) Fig. 29 clockwise to

increase the depth of drive, rotate the knob counterclockwise to decrease the depth of

drive. Test fire another fastener and check depth. Repeat as necessary to achieve

desired results. The amount of air pressure required will vary depending on the size of

the fastener and the material being fastened. Experiment with the air pressure setting to

determine the lowest setting that will consistently perform the job at hand. Air pressure

in excess of that required can cause premature wear and/or damage to the tool.

Fig. 26

Fig. 27

OPERATING INSTRUCTIONS

Fig. 28

639224-00 FSNS100 Stapl 12/14/05 7:25 AM Page 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Pas de commentaire

Black & Decker FSNS100 Manuel d'instructions Page 8