Black & Decker FSNS100 Manuel d'instructions télécharger pdf (Page 7)

The FSNS100 Stapler is designed to install 18 ga. narrow crown staples of various

lengths from

/8" to 1" long. Narrow crown staples are loaded into the magazine from

the top.

POWER SOURCE

This tool is designed to operate on clean, dry, compressed air at regulated pressures

between 70 and 120 PSI (Pounds per Square Inch)

(4.8 to 8.3 BAR)

. The preferred

system would include a filter, a pressure regulator, and an automatic oiler located as close

to the tool as possible, within 15 ft/4.6 m is ideal.

All compressed air contains moisture and other contaminates that are detrimental to

internal components of the tool. An air line filter will remove most of these contaminates

and significantly prolong the life of the tool. If an in-line oiler is not available: place five or

six drops of air tool oil into the tool’s air inlet on a daily basis.

The tool is equipped with a

/4" male “quick connector”. The tool must always be

connected to the air supply with a coupling such that all pressure is removed from the tool

when the coupling is disconnected.

PREPARING THE TOOL

Keep tool pointed in a safe direction when loading nails.

Never load nails with the contact trip or trigger activated.

1. After reading and understanding this entire manual, connect tool to

air supply. (Fig. 22)

2. Depress latch and slide magazine cover open. (Fig. 23)

3. Insert a strip of approved fasteners. (Fig. 24) Orient fasteners with points down

in the magazine.

4. Push magazine cover closed. (Fig. 25)

5. Observe the low fastener indicator (A) Fig. 26 and reload as needed.

6. Adjust directional exhaust deflector (A) Fig. 27, so that the exhaust air

or debris will be directed away from the operator. Grasp the deflector

and rotate it to the desired position for the current application.

FUNCTIONAL DESCRIPTION

Fig. 22

Fig. 23

Fig. 24 Fig. 25

639224-00 FSNS100 Stapl 12/14/05 7:25 AM Page 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 37 38

Pas de commentaire

Black & Decker FSNS100 Manuel d'instructions Page 7