Black & Decker 625779-00 Manuel d'instructions télécharger pdf (Page 6)

RECOMMENDED MINIMUM WIRE SIZE

FOR EXTENSION CORDS

TOTAL LENGTH OF CORD

25 FT. 50 FT. 75 FT. 100 FT. 125 FT. 150 FT. 175 FT.

7.6 M 15.2 M 22.9 M 30.5 M 38.1 M 45.7 M 53.3 M

WIRE SIZE AWG

18 18 16 16 14 14 12

9. Use only the supplied charger when charging your tool. The use of any other

charger could damage the drill or create a hazardous condition.

10. Use only one charger when charging.

11. Do not attempt to open the charger. There are no customer serviceable parts

inside. Return to any authorized Black & Decker service center.

12. DO NOT incinerate the battery packs even if they are severely damaged or

completely worn out. The batteries can explode in a fire.

13. A small leakage of liquid from the battery cells may occur under extreme usage,

charging or temperature conditions. This does not indicate a failure. However, if the

outer seal is broken and this leakage gets on your skin:

a. Wash quickly with soap and water.

b. Neutralize with a mild acid such as lemon juice or vinegar.

c. If the battery liquid gets in your eyes, flush them with clean water for a minimum of

10 minutes and seek immediate medical attention. MEDICAL NOTE: The liquid is a

25-35% solution of potassium hydroxide.

Charging the Battery Pack

THE BATTERY PACK IS NOT FULLY CHARGED AT THE FACTORY. BEFORE

ATTEMPTING TO CHARGE THE BATTERY PACK, THOROUGHLY READ ALL OF

THE SAFETY INSTRUCTIONS.

The charger is designed to use standard household 120 volt 60 Hz power.

1. Plug the charger into any standard 120 Volt 60 Hz electrical outlet. NOTE: Do not

charge by means of an engine generator or DC power source. Use only 120V

2. Slide the charger onto the battery pack as shown in Figure A and let the battery

charge initially for 9 hours. After the initial charge, under normal usage, your

battery pack should be fully charged in 3 to 6 hours.

3. Unplug charger, and remove the battery pack. Place the battery in the tool and

be certain that it is inserted fully into the tool cavity until it “clicks” into

place.

NOTE: To remove the battery from the tool, press down on the release button on

the back of the battery (Figure B) and slide out.

625779-00 BDBN1200Booklet 8/9/04 9:55 AM Page 6

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Pas de commentaire

Black & Decker 625779-00 Manuel d'instructions Page 6