Black & Decker FIRESTORM FS210LS Manuel d'instructions Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 68
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
24
USING AUXILIARY WOODFACING ON
RIP FENCE
Wood facings (A) Fig. 51 are necessary on some special
operations to one or both sides of the rip fence. The wood
facing is attached to the fence with screws through the
holes in the fence. Most work will require a 3/4 in. stock,
although an occasional job may require 1in. facing.
Fig. 54 Fig. 55
Fig. 53
1. Dadoing is cutting a rabbet or wide groove into the
work. Most dado head sets are made up of two outside
saws and four or five inside cutters, (Fig. 53). Various
combinations of saws and cutters are used to cut
grooves from 1/8 in. to 13/16 in. for use in shelving,
making joints, tenoning, grooving, etc. The cutters are
heavily swaged and must be arranged so that this heavy
portion falls in the gullets of the outside saws, as shown
in Fig. 54. The saw and cutter overlap is shown in Fig. 55,
(A) being the outside saw, (B) an inside cutter, and (C) a
paper washer or washers, used as needed to control the
exact width of groove. A 1/4 in. groove is cut by using
the two outside saws. The teeth of the saws should be
positioned so that the raker on one saw is beside the
cutting teeth on the other saw.
A
B
C
THE BLADE GUARD AND SPLITTER
ASSEMBLY CANNOT BE USED WHEN
DADOING. IT MUST BE REMOVED.
ACCESSORY DADO CUTTERHEAD
Fig. 52
A
Before dadoing, loosen wing nut (A) Fig. 52 and take
off the blade guard and splitter assembly (B). Keep
assembly handy to replace it after dadoing.
B
Fig. 51
A
NOTE: THE MAXIMUM WIDTH DADO CUT FOR THIS
SAW IS 1/2 INCH.
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Commentaires sur ces manuels

Pas de commentaire