Black & Decker FIRESTORM FS210LS Manuel d'instructions télécharger pdf (Page 21)

ADJUSTING BLADE PARALLEL TO

MITER GAGE SLOTS

The blade was adjusted parallel to the miter gage slots

at the factory. In order to insure accurate cuts and help

prevent kickback when cutting, this adjustment should

be rechecked and if necessary, readjusted as follows:

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Raise the blade to its highest position and adjust the

blade so it is 90 degrees to the table.

3. Select a tooth on the saw blade that is set to the left.

Mark this tooth with a pencil or marker.

4. Using a combination square, place the body (A)

Fig. 42, of the square against the miter gage slot and

adjust the blade (B) of the square until it just touches the

marked tooth, as shown.

5. Rotate the blade and check the same marked blade

tooth at the rear of the saw table in the same manner, as

shown in Fig. 43.

6. If the front and back measurements (Figs. 42 and 43)

are not identical, you can adjust the blade. Start by

loosening the nuts below the four screws (C) Fig. 44 on

the table. Then loosen the screws (C). Carefully move

the saw blade until the blade is parallel to the miter

gauge slot. When done, tighten four nuts under the table

and the four screws (C) Fig. 44 securely.

NOTE: If sufficient adjustment cannot be achieved by

loosening screws (C), screws (D) may also be loosened

if absolutely necessary to make the adjustment.

NOTE: Guard has been removed for illustrative

purposes only.

CHANGING THE BLADE

DISCONNECT MACHINE FROM POWER

SOURCE. USE ONLY 10 in. DIAMETER

SAW BLADES RATED FOR 5000 RPM OR HIGHER

WITH 5/8 in. ARBOR HOLES.

1. Raise the saw blade to its maximum height and

remove the table insert (A) Fig. 45.

2. Using the open end wrench (B) Fig. 45, place open

end of wrench on flats on inside blade flange to keep the

saw arbor from rotating and remove arbor nut (C) with

wrench (D). Turn nut (C) counterclockwise to remove.

Remove outside blade flange (E) and saw blade (F).

3. Assemble new blade, making certain teeth of blade

are pointing down at the front of the saw table and

assemble the outside blade flange (E) Fig. 45, and arbor

nut (C). Tighten nut (C) with wrench (D) by turning nut

clockwise while holding arbor steady with other wrench

(B).

4. Replace table insert.

Fig. 42

Fig. 43

Fig. 44

Fig. 45

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Black & Decker FIRESTORM FS210LS Manuel d'instructions Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Black & Decker FIRESTORM FS210LS