Black & Decker FIRESTORM FS210LS Manuel d'instructions télécharger pdf (Page 20)

2020

RIP FENCE OPERATION

AND ADJUSTMENTS

1. To move the rip fence (A) Fig. 40, along the table, lift

up fence locking lever (B), slide the fence to the desired

location on the table and push down fence locking lever

(B) to lock the fence in position.

2. A pointer is supplied to indicate the distance the fence

is positioned away from the saw blade. If an adjustment

to the pointer is required, loosen the screw (C) Fig. 40,

that fastens the pointer to the fence bracket and adjust

the pointer accordingly. Then, tighten screw (C).

3.IMPORTANT: THE RIP FENCE MUST BE PROPERLY

ALIGNED TO THE MITER GAGE SLOT IN ORDER TO

HELP PREVENT KICKBACK WHEN RIPPING.

4. The saw blade is set parallel to the miter gage slot at

the factory and the fence must be parallel to the miter

gage slot in order to do accurate work and prevent

kickback when ripping. To check the alignment:

5. Position the fence at one end of the miter gage slot.

Clamp the fence to the table by pushing down the

locking lever. The edge of the fence should then line up

parallel with the miter gage slot.

6. If an adjustment is necessary, proceed as follows:

Fig. 40

MITER GAGE OPERATION AND ADJUSTMENTS

When straight cross-cutting (blade set 90 degrees to the table) the miter gage can be used in either table slot. When

bevel cross-cutting (blade tilted) only use the miter gage in the right table slot where the blade is tilted away from the

miter gage and your hands.

This miter gage is equipped with individually adjustable index stops at 90 degrees and 45 degrees right and left.

Adjustment to the index stops can be made by loosening lock nuts (B) Fig. 41, and tightening or loosening the three

adjusting screws (C) until they contact the other end of stop pin (D) when the miter gage is at 90 and 45 degrees to the

saw blade. Then, tighten lock nuts (B).

To operate the miter gage, simply loosen lock knob (E) Fig. 41, and move the body of the miter gage to the desired

angle. When the stop pin (D) is pushed in, the miter gage body will stop at 90 degrees and 45 degrees right and left.

To rotate the miter gage body past these points, pull out stop pin (D).

Fig. 41

7. Loosen the two 3/16 in. allen head screws (D) Fig. 40,

and lift up locking lever (B). Then while holding the fence

bracket firmly toward the front of the saw, move the rear

end of the fence (A) until it is parallel with the miter gage

slot. Then tighten two screws (D) and push down locking

lever (B).

8. The clamping action of the fence (A) Fig. 40, can be

adjusted by lifting up locking lever (B) and turning screw

(E) clockwise to increase or counterclockwise to

decrease the clamping action of the fence.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Black & Decker FIRESTORM FS210LS Manuel d'instructions Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Black & Decker FIRESTORM FS210LS