Black & Decker FIRESTORM FS210LS Manuel d'instructions télécharger pdf (Page 11)

STAND ASSEMBLY

1. The stand legs have protrusions which align with the

holes in the top and bottom brackets. Assemble the

stand as shown in Fig. 9A, using 16 carriage bolts and

hex lock nuts. Do not completely tighten the hardware at

this time.

A-Top front bracket (with logo)

B-Top rear bracket

C-Bottom side brackets

D-Bottom front and rear brackets

E-Top side brackets

F-Foot

IMPORTANT: THE TOP, FRONT, AND REAR

BRACKETS (A&B) FIG. 9A, ARE LONGER THAN THE

TOP SIDE BRACKETS (E) FIG. 9A. THE BOTTOM

FRONT AND REAR BRACKETS (D) FIG. 9A, ARE

LONGER THAN THE BOTTOM SIDE BRACKETS (C).

2. Assemble the rubber feet (F) Fig. 9A. NOTE: Each

rubber foot is provided with holes for mounting the

stand to the floor surface if required.

ATTACHING DUST BAG

1. Attach the dust bag to the bag frame and place the

frame of the dust bag inside the saw stand as shown in

Fig. 9B. Refer to the section below to attach this

assembly to the saw.

SAW TO STAND

1. Turn saw table face down on a piece of cardboard to

protect the table surface. Place stand upside down onto

saw and align the four holes in the stand with the

mounting holes in the saw.

2. Using the 2 longer screws for the front, place a M8 flat

washer on a M8X1.25X45mm hex head screw. Insert the

hex head screw through the mounting hole in the saw

and the mounting hole in the stand. Place another M8

flat washer on the hex screw and thread a M8X1.25 hex

nut on the screw and loosely tighten. Repeat this

process to complete another hole in the saw front.

Using the 2 shorter screws for the back, place a M8 flat

washer on a M8X1.25X30mm hex head screw in the

back of saw. Insert the hex head screw through the

mounting hole in the saw and the mounting hole in the

stand. Place another M8 flat washer on the hex screw

and thread a M8X1.25 hex nut on the screw and loosely

tighten. Repeat this process to complete another hole in

the saw back.

3. Then, turn saw table face up, as shown in Fig. 9C

(Saw is shown fully assembled here).

4. Push down on top of the saw so the legs of the stand

adjust to the surface of the floor and tighten all stand

hardware and hardware which secures saw to stand.

Fig. 9A

Fig. 9C

Fig. 9B

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Black & Decker FIRESTORM FS210LS Manuel d'instructions Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Black & Decker FIRESTORM FS210LS