Black & Decker CTL36 Manuel d'instructions télécharger pdf (Page 6)

ASSEMBLY INSTRUCTIONS

UNPACKING - (FIGURE B)

Remove the frame / upper handle assembly, mid handle,

battery, wheels, drag bar, tines and hardware bag from the

carton.

The hardware bag contains:

1. Safety Key (1)

2. Long Carriage Bolts (2)

3. Short Carriage Bolts (4)

4. Flanged Hex Nuts (4)

5. Knobs (2)

6. Wheel machine bolts (2)

7. Wheel washers (4)

8. Steel Pin (1)

9. Long Hairpin Cotter Pins (2)

10. Short Hairpin Cotter Pin (1)

ASSEMBLY

DANGER: TO PREVENT SERIOUS PERSONAL INJURY, DO NOT INSERT SAFETY KEY UNTIL FULLY

COMPLETING GARDEN TILLER ASSEMBLY.

Tools required for assembly:

Adjustable or 10 mm wrench

MID HANDLE ASSEMBLY - (FIGURE C)

Ensure that the cord is not pinched andis routed on thetop side ofthe handles.

1. Align the holes in the mid handle with holes in the frame and insert the

short carriage bolts (C-1) through the holes. Be careful not to trap or

pinch cord

2. Place a nut (C-2) on each bolt and tighten securely with a 10 mm or

adjustable wrench.

UPPER HANDLE ASSEMBLY - (FIGURE D)

Ensure that the cord isnot pinchedand isrouted on the top side ofthe handles.

1. Align the holes in the upper handle with holes in the mid handle and

insert the long carriage bolts (D-1) through the holes. Be careful not

to trap or pinch cord

2. Hand tighten plastic knob (D-2) onto carriage bolts.

3. Clip the lower part of the cord into the lower cord clip (D-3) after the

handles are fastened together.

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Pas de commentaire

Black & Decker CTL36 Manuel d'instructions Page 6