Black & Decker CTL36 Manuel d'instructions télécharger pdf (Page 12)

TROUBLESHOOTING GUIDE

PROBLEM RECOMMENDATION

1. Tiller doesnʼt run when bail handle is activated. A. Check to make sure safety key has been

installed and is fully seated and that button on

switch housing is being completely depressed.

B. The tiller is protected from overheating with a

manually resettable circuit breaker. It may

require resetting if an overload condition existed.

Remove safety key. Press the circuit breaker

button at the rear left side of the motor housing.

Reinsert safety key and restart tiller.

C. Release bail handle to turn tiller off. Remove

safety key and battery pack, turn tiller over and

check that tines are free to turn.

D. Check that the battery cavity is free of debris

and is connected properly.

E. Has battery been fully charged? Plug in charger

and wait for green LED to come on.

2. Motor stops while tilling. A. The tiller is protected from overheating with a

manually resettable circuit breaker. It may

require resetting if an overload condition existed.

Remove safety key. Press the circuit breaker

button at the rear left side of the motor housing.

Reinsert safety key and restart tiller.

B. Release bail handle to turn tiller off. Remove

safety key and battery pack, turn tiller over and

check that tines are free to turn.

C. Check that the battery cavity is free of debris

and is connected properly.

D. Has battery been fully charged? Plug in charger

and wait for green LED to come on.

E. If the tiller continues to stop operating and the

tiller circuit breaker trips, slow the tilling pace

down and do not dig as deep.

3. Battery charger LED is not on. A. Check plug connection. Unplug charger, wait a

few seconds. Plug charger in again to see if

battery charger LED comes on.

B. There are two charge ports on your tiller - at the

upper handle end and at the battery pack. The

battery pack charge port is accessible only when

removed from the tiller. Try both charge ports to

see if charger LED comes on.

C. Replace charger.

4. Battery charger LED does not change from red to green. A. Unplug charger and wait a few seconds. Plug in

again and leave on charge for minimum 12 to 20

hours.

B. If charger LED is not green, battery may need to

be diagnosed. Take to authorized service center.

MAINTENANCE

WARNING: To prevent serious personal injury, remove safety key from unit before performing any maintenance.

WARNING: Do not wash garden tiller with a hose. Avoid getting water on motor and electrical connections. After

tilling, the mud and debris may be easily removed from the tines by removing them from the tiller first. You may spray

the tines with water while they are detached and away from the tiller.

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of

the tool into a liquid. IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment

should be performed by authorized service centers or other qualified service organizations, always using identical

replacement parts.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Black & Decker CTL36 Manuel d'instructions Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses Black & Decker CTL36