Black & Decker CTL36 Manuel d'instructions télécharger pdf (Page 11)

ADJUSTING THE WHEEL HEIGHT POSITION - (FIGURE O)

DANGER: Avoid accidental starting. Release bail handle to turn tiller

off, wait until the tines stop and remove safety key prior to adjusting wheel

height position.

The Tiller has three wheel height positions.

owest Position - When the wheels are in their lowest position this will

allow easy transportation to and from your work area.

Middle Position - In the middle position the wheels will be lifted up, but

can still contact the ground. This may provide some users additional

control and stability while tilling. It is recommended to raise or remove the

drag bar when tilling in this wheel position.

Highest Position - In the highest position the wheels will not contact the

ground. This position can be used for deep tilling.

1. To adjust the wheel height position, grasp the top of the mid handle

(O-1) and lift slightly to raise the wheels off the ground.

2. Grasp the wheel height adjustment sleeve (O-2) under the wheel

height adjustment knob (O-3) with your index and middle finger and

slide up to release.

3. Move the knob to the desired detent position.

USING THE TILLER

1. Move the tiller to the work area prior to starting the motor. Transport the tiller by pushing or pulling it along on its

wheels with the safety key removed.

2. Start the tiller following all steps under “ON-OFF SWITCH” on the previous page.

3. With both hands on the upper handle, slowly pivot the tiller forward until the tines make contact with the soil.

4. Once the tines are in the ground, till at a moderate pace until you are familiar with the controls and the handling of

the tiller.

5. To adjust the tilling depth, adjust the drag bar bracket and wheel height adjustment position as required.

6. For deeper tilling move your tiller slowly back and forth. Work the same area over and over until the desired depth is

reached.

CIRCUIT BREAKER - (FIGURE P)

The tiller is protected from overheating with a manually resettable circuit

breaker. It may require resetting if an overload condition existed.

1. Remove the safety key from the tiller switch housing.

2. Press the circuit breaker button (P-1) at the rear left side of the

motor housing.

3. Insert the safety key and restart tiller.

NOTE: The tiller may need a few minutes to cool down. Pushing the

breaker button back in will reset it.

UNJAMMING THE TINES - (FIGURE Q)

DANGER: Avoid accidental starting. Release bail handle to turn tiller

off, wait until the tines stop and remove safety key prior to unjamming tines.

To unjam the tines:

1. Remove the safety key (Q-1) from the tiller switch housing.

2. Insert the safety key into the tine unjam port (Q-2) as shown, push in

on the key and turn clockwise.

3. As the key is rotated, the tines will slowly rotate unjamming the debris.

4. If the debris is not easily removed with the above operation, the tines

may have to be removed.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Black & Decker CTL36 Manuel d'instructions Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses Black & Decker CTL36