Black & Decker CTL36 Manuel d'instructions télécharger pdf (Page 10)

OPERATING INSTRUCTIONS

KNOW YOUR TILLER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TILLER. See “Func-

ional Description” to familiarize yourself with the location of various controls and adjustments. Save this manual for

future reference.

SAFETY KEY

DANGER:

SHARP MOVING TINES. In order to prevent accidental start-up or unauthorized use of your

Cordless Tiller, a removable safety key I-1 has been incorporated into the design of your tiller. The tiller will be

completely disabled when the Safety Key has been removed. With the Safety Key removed, you will have access to the

charger receptacle I-3.

NOTE: THE SAFETY KEY HAS A HOLE IN THE CENTER TO ALLOW FOR STORAGE ON A NAIL, OUT OF THE

REACH OF CHILDREN. DO NOT TETHER SAFETY KEY TO TILLER.

DANGER: ROTATING TINES CAN CAUSE SERIOUS INJURY. TO PREVENT SERIOUS INJURY, REMOVE

SAFETY KEY WHEN UNATTENDED, OR WHEN CHARGING, CLEANING, SERVICING, TRANSPORTING,

LIFTING, OR STORING TILLER.

TO TURN TILLER ON

Insert safety key L-1 into the switch housing, until it is fully seated inside

housing. The tiller is now operational.

DANGER: SHARP MOVING BLADE. NEVER ATTEMPT TO

OVERRIDE THE OPERATION OF THIS SWITCH/BAIL HANDLE AND

SAFETY KEY SYSTEM AS SERIOUS INJURY COULD RESULT.

ON-OFF SWITCH (BAIL HANDLE) - FIGURE M

Your tiller is equipped with a special on-off switch system. To operate the system:

1. Make sure safety key is inserted as described above.

2. Push button M-1 on side of switch housing.

Note: Starting the tiller motor also starts the tilling action.

3. Stand behind the tiller and pivot the tiller slightly toward the rear, so

that its weight is resting on its wheels and the tines are not in contact

with the ground.

4. To operate the switch, pull the bail handle (switch lever) M-2 to the

handlebar M-3 and hold it against the tiller handle to keep it running.

5. To turn the tiller off, release the bail handle.

DANGER: NEVER ATTEMPT TO OVERRIDE THE OPERATION OF

THIS SWITCH.

ADJUSTING THE DRAG BAR - (FIGURE N)

DANGER: Avoid accidental starting. Release bail handle to turn tiller

off, wait until the tines stop and remove safety key prior to adjusting the drag

bar.

To adjust the drag bar, remove the hairpin cotter pin (N-1) and locating

pin (N-2). Align the drag bar hole in the desired position with the frame

hole. Reinsert bolt and cotter pin.

For deeper tilling, the drag bar should be positioned in the lowest position.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Black & Decker CTL36 Manuel d'instructions Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses Black & Decker CTL36