Black & Decker CM1836 Manuel d'instructions Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
TROUBLE SHOOTING GUIDE
PROBLEM SOLUTION
1. Mower doesnʼt run when bail handle A. Check to make sure safety key has been installed and is fully seated and
that button on switch housing is being completely depressed.
is activated.
B
. Release bail handle to turn mower off. Remove safety key, turn mower over
and check that blade is free to turn. If not free, return to an authorized
Black & Decker servicer. Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for green light to
come on.
2. Motor stops while mowing. A. Release bail handle to turn mower off. Remove safety key, turn mower over
and check that blade is free to turn. If not free, return to an authorized
B
lack & Decker servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start mower.
C. Has battery been fully charged? Plug in charger and wait for green light to
come on.
D. Avoid overloading the mower. Slow down the cutting pace by pushing
mower slower or raise the cut height. Or both.
3. Mower runs but cutting performance is unsatisfactory, A. Has battery been fully charged? Plug in charger and wait for green light to
come on.”
or does not cut entire lawn.
B. Release bail handle to turn mower off. Remove safety key. Turn mower over
and check:
Blade for sharpness - Keep blade sharp.
Deck and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass condition. Raise
cutting height.
4. Mower is too hard to push. A. Raise cutting height to reduce deck drag on grass. Check each wheel for
free rotation.
5. Mower is abnormally noisy and vibrates. A. Release bail handle to turn mower off. Remove safety key. Turn mower on
side and check blade to ensure it has not been bent or damaged. If blade is
damaged, replace with a Black & Decker replacement blade. If the
underside of the deck is damaged return mower to a Black & Decker
Authorized service center.
B. If there is no visible damage to the blade and the mower still vibrates:
Release bail handle to turn mower off, remove safety key and remove
blade. Rotate blade 180 degrees and retighten. If mower still vibrates,
return the mower to an authorized Black & Decker service center.
6. Battery charger LEDʼs not on. A. Check plug connection.
B. Replace charger.
7. Battery charger LED does not flip to green. A. Battery needs to be diagnosed. Take to authorized service center.
8. Mower not picking up clippings with bag. A. Remove mulch plate when bagging.
B. Chute clogged. Release bail handle to turn mower off. Remove safety key.
Clear chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten length of the
cut.
D. Bag full. Empty bag more often.
9. When mulching there are clippings visible. A. Too much cut grass. Raise cutting height of wheels to shorten length of the
cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
10. Low or diminished run-time after many uses A. Return to Black & Decker Authorized Service location - may need new
battery.
NOTE
Should the red light remain on after charging the battery for 24 hours on initial charge, the mower can still be used. The battery may need to be
“conditioned” requiring a few battery charge and discharge cycles before the green indicator light comes on.
THIS IS ONLY A GUIDE INTENDED TO ENABLE YOU TO PERFORM VISUAL CHECKS AND SIMPLE TESTS. SHOULD NONE OF THE
SOLUTIONS PROVIDE SATISFACTION OR IMPROVE PERFORMANCE CALL 1-800-544-6986 (1-800-54-HOW-TO) TO SPEAK TO A
CONSUMER SERVICE REPRESENTATIVE OR TAKE THIS MOWER TO THE CLOSEST AUTHORIZED BLACK & DECKER SERVICE
CENTER FOR SERVICING.
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
See ‘Tools-
Electric’
Yellow Pages –
for Service &
Sales
15
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Commentaires sur ces manuels

Pas de commentaire