Black & Decker BDL300S Manuel d'instructions télécharger pdf (Page 3)

INSTALLING THE BATTERY

Ensure laser on/off switch is in the left “OFF” position.

Remove the battery compartment cover by pressing the

tab of the cover in towards the center of the laser and out

as shown in figure 3. Connect a fresh 9 volt alkaline

battery making sure to match (+) and (-) terminals

correctly. Replace the battery compartment cover.

ASSEMBLY / SET-UP

UNFOLDING THE LASER LEGS

To open the 360° Laser:

1.) Choose a relatively smooth and level surface away

from other work site activity to position the tripod.

2.) Unfasten the strap that is around the outside portion of

the laser and unfold the three sections of the laser

housing which become the legs of the tripod.

3.) Lock the legs in place, by pushing in on the top portion

of the hinge until it snaps into place as shown in figure 4.

CAUTION: Make sure tripod is secure and sitting

on a flat and stable surface.

ADJUSTING THE TRIPOD

The tripod is adjustable from its

lowest position of approximately 27

inches (686mm) shown in figure 5 to

a maximum height of 5 feet

(1524mm) shown in figure 6.

Extend any or all of the 5 sections of the tripod to reach the

approximate desired height. Extend each section by gently sliding

each tube out until it stops and then pull slightly harder on each

section to lock.

When the approximate desired height is obtained, use the fine

adjust knob shown in figure 8 to raise the laser to the final desired

height. The fine adjustment knob will raise the laser up to an

additional 7 inches (178mm) high.

First, loosen the lock knob as shown in figure 7.

Turn the fine adjust knob (figure 8) until the desired height is

reached. Tighten the lock knob (fig. 7) to secure the tripod at the

adjusted height.

Lock Knob

Fine Adjust

Knob

586017-00 BDL300S laser 7/30/03 8:51 AM Page 3

1 2 3 4 5 6 7 8 ... 15 16

Pas de commentaire

Black & Decker BDL300S Manuel d'instructions Page 3