Black & Decker D1700 Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 15
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
2
1
When using your iron, basic safety precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS BEFORE USING.
Use iron only for its intended use.
To protect against a risk of electric shock, do not immerse the iron
in water or other liquid.
The iron should always be turned ”Off” (refer to “How to Use” section)
before plugging or unplugging from outlet. Never yank cord to disconnect
from outlet; instead grasp plug and pull to disconnect.
Do not allow cord to touch hot surfaces. Let iron cool completely before
putting away. Loop cord loosely around the iron when storing.
Always disconnect iron from electrical outlet when with or emptying of
water and when not in use.
Do not operate iron with a damaged cord or if the iron has been dropped
or damaged. To avoid the risk of electric shock, do not disassemble the
iron, take it to a qualified serviceman for examination and repair.
Incorrect reassembly can cause a risk of electric shock when the iron
is used.
Close supervision is necessary for any appliance being used by or near
children. Do not leave iron unattended while connected or on an ironing
board.
Burns can occur from touching hot metal parts, hot water, or steam.
Use caution when you turn a steam iron upside down or use the surge
of steam — there may be hot water in the water tank. Avoid rapid
movement of iron to minimize hot water spillage.
SPECIAL INSTRUCTIONS
To avoid a circuit overload, do not operate another high-wattage
appliance on the same circuit.
If an extension cord is absolutely necessary, a cord rated at 15-amperes
and 120-volt, or 7-ampere and 220-volt cord should be used. Cords rated
for less amperage may overheat. Care should be taken to arrange the cord
so that it cannot be pulled or tripped over.
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS.
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug will fit into a polarized outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Do not attempt to modify the plug
in any way.
TAMPER-RESISTANT SCREW
Warning: This appliance is equipped with a tamper-resistant screw to prevent
removal of the outer cover. To reduce the risk of fire or electric shock, do not
attempt to remove the outer cover. There are no user-serviceable parts
inside. Repair should be done only
by authorized service personnel.
Note: If the power supply cord is damaged, it should be replaced by
qualified personnel or in Latin America by an authorized service center.
D1700 6/1/07 10:44 AM Page 2
Vue de la page 1
1 2 3 4 5 6 7 ... 14 15

Commentaires sur ces manuels

Pas de commentaire