Black & Decker Heat Gun HOT AIR TOOL Manuel d'utilisateur télécharger pdf (Page 8)

MODEL HEAT PRO PLUS ENGLISH 8

Model HEAT PRO PLUS How-to Use

The Model HEAT PRO PLUS kit includes one hot air

tool, one concentrator nozzle and one scraper nozzle.

Model HEAT PRO PLUS Specifications

Wattage up to 1300 Watts

Temperature Dual Temperatures

Low 600°F / High 1100°F

Volts 120 Volts

AMPS 11 AMPS

Output 74 BTU

Weight 1.8 lbs.

Cord Length 6 feet

Settings High, Low, Cool, Off

Operation of the Model HEAT PRO PLUS

The following instructions are a general guideline

for using the Model HEAT PRO PLUS hot air tool.

Every project is different so use these instructions

as a starting point to determine the best heat set-

ting and distance for your project.

Before plugging the Model HEAT PRO PLUS into

an electrical outlet make sure the switch is in the

Off position.

1. Plug into a standard 3-hole outlet.

2. To start, slide the switch to either the Low or

High position. The motor-driven fan noise will

indicate the unit is running. The heating coil

will light up and slowly turn red.

Note: Smoke may appear during the initial start

up due to the burning of manufacturing oils.

The smoke should disappear in less than a

minute.

 Caution: If the blower motor in the hot air tool

does not turn on when the switch is set to

either Low or High, turn the switch to Off

immediately. The heating element will burn

out if it is not cooled by the blower.

3. For instructions on how to strip paint go to

section HOT AIR TOOL OPERATIONAL GUIDE-

LINES, How to Strip Paint.

4. To turn off when finished, slide the switch to

the Cool position, point the nozzle up and let

run until cool. Then slide the switch to the Off

position and unplug. Set the Model HEAT PRO

PLUS upright on a stable, level surface. This

will speed up the cooling process because the

air will flow naturally upward over the heating

element. Allow the Model HEAT PRO PLUS to

cool completely. Make sure the Model HEAT

PRO PLUS is completely cooled before storing.

How To Attach Accessories to the Model HEAT

PRO PLUS

1. Set the Model HEAT PRO PLUS upright on a

level surface, make sure tip is cool.

2. Set the accessory nozzle on the top of the open

nozzle and push firmly into place.

3. To remove, set hot air tool with nozzle facing

up; wait for it to cool.

4. Pull the accessory nozzle off the top using a

twisting motion and straight pull.

5. Only use accessories designed for this hot air

tool.

Concentrator

Nozzle

Scraper

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Black & Decker Heat Gun HOT AIR TOOL Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs des ménages Black & Decker Heat Gun HOT AIR TOOL